HD74CDCF2509B Datasheet, PDF (1/11 Pages) Hitachi Semiconductor – 140 MHz, 0 to 85°C Operation 3.3-V Phase-lock Loop Clock Driver

HD74CDCF2509B
140 MHz, 0 to 85°C Operation
3.3-V Phase-lock Loop Clock Driver
ADE-205-224F (Z)
7th. Edition
January 2000
Description
The HD74CDCF2509B is a high-performance, low-skew, low-jitter, phase-lock loop clock driver. It uses a
phase-lock loop (PLL) to precisely align, in both frequency and phase, the feedback (FBOUT) output to the
clock (CLK) input signal. It is specifically designed for use with synchronous DRAMs. The
HD74CDCF2509B operates at 3.3 V V_CC and is designed to drive up to five clock loads per output.
One bank of five outputs and one bank of four outputs provide nine low-skew, low-jitter copies of the input
clock. Output signal duty cycles are adjusted to 50 percent independent of the duty cycle at the input clock.
Each bank of outputs can be enabled or disabled separately via the control (1G and 2G) inputs. When the
G inputs are high, the outputs switch in phase and frequency with CLK; when the G inputs are low, the
outputs are disabled to the logic-low state.
Unlike many products containing PLLs, the HD74CDCF2509B does not require external RC networks.
The loop filter for the PLL is included on-chip, minimizing component count, board space, and cost.
Because it is based on PLL circuitry, HD74CDCF2509B requires a stabilization time to achieve phase lock
of the feedback signal to the reference signal. This stabilization time is required, following power up and
application of a fixed-frequency, fixed-phase signal at CLK, as well as following any changes to the PLL
reference or feedback signals. The PLL can be bypassed for test purposes by strapping AV_CC to ground.
Features
• Supports PC133 and meets “PC SDRAM registered DIMM specification, Rev. 1.1”
• Phase-lock loop clock distribution for synchronous DRAM applications
• External feedback (FBIN) pin is used to synchronize the outputs to the clock input
• No external RC network required
• Support spread spectrum clock (SSC) synthesizers
• Supports frequencies up to 140 MHz
• 0 to 85°C operating range