S8865 Datasheet, PDF (5/6 Pages) Hamamatsu Corporation – Photodiode array combined with signal processing circuit chip

Photodiode array with amplifier S8865 series
I Dimensional outline (unit: mm)
51.2
+0.2
-0
P_{2.54 × 11 = 27.94}
1
12
(× 12) 0.76
SIGNAL PROCESSOR IC CHIP
PHOTODIODE ARRAY
1.27
2.54
5.6
40.0
PHOTODIODE 1 ch
(× 4) 2.2
PHOSPHOR
SCREEN *¹²
1.6
DIRECTION OF SCAN
*11: Distance from the bottom of the board to the center of active area
Board: G10 glass epoxy
Connector: PRECI-DIP DURTAL 800-10-012-20-001
*12:Photodiode array with phosphor screen: S8865-64G/-128G only
· Material Gd2O2S: Tb
· Phosphor thickness 300 µm Typ.
· Detectable energy range 30k to 100 keV
KMPDA0164EB
I Pin connection
Pin No.
Symbol
1
RESET
2
CLK
3
Trig
4
EXTSP
5
Vms
6
Vdd
7
GND
8
EOS
9
Video
10
Vref
11
Vgain
12
Vpd
Name
Reset pulse
Clock pulse
Trigger pulse
External start pulse
Master/slave selection supply voltage
Supply voltage
Ground
End of scan
Video output
Reference voltage
Gain selection terminal voltage
Photodiode voltage
Note
Pulse input
Pulse input
Positive-going pulse output
Pulse input
Voltage input
Voltage input
Negative-going pulse output
Negative-going output with respect to Vref
Voltage input
Voltage input
Voltage input
I Gain selection terminal voltage setting
Vdd: High gain (Cf: 0.5 pF) GND: Low gain (Cf: 1 pF)
I Master/slave selection voltage Vms and external start pulse EXTSP settings
Set to A in the table below in most cases.
To sequentially read out signals from two or more sensors linearly connected, set the 1st sensor to A and the 2nd or later
sensors to B. The CLK and RESET pulses should be shared with each sensor and the video output terminal of each sensor
connected together.
A Parallel readout, serial readout at 1st sensor
B Serial readout at 2nd and later sensors
Vms
Vdd
GND
EXTSP
Vdd
Preceding sensor EOS should be input
I Readout circuit
Check that pulse signals meet the required pulse conditions before supplying them to the input terminals.
Video output should be amplified by an operational amplifier that is connected close to the sensor.
5