S11500-1007 Datasheet, PDF (3/7 Pages) Hamamatsu Corporation – Enhanced near infrared sensitivity: QE=40% (λ=1000 nm), back-thinned FFT-CCD

CCD area image sensor
S11500-1007
Electrical characteristics (Ta=25 °C)
Parameter
Symbol
Min.
Signal output frequency
fc
-
Vertical shift register capacitance
CP1V, CP2V
Horizontal shift register capacitance
CP1H, CP2H
-
Summing gate capacitance
CSG
-
Reset gate capacitance
CRG
-
Transfer gate capacitance
Charge transfer efficiency*³
CTG
-
CTE
0.99995
DC output level
Vout
14
Output impedance
Power consumption*⁴
Zo
-
P
-
*3: Charge transfer efficiency per pixel, measured at half of the full well capacity
*4: Power consumption of the on-chip amplifier plus load resistance
Typ.
0.25
3000
180
30
30
75
0.99999
16
3
13
Max.
Unit
1
MHz
-
pF
-
pF
-
pF
-
pF
-
pF
-
-
18
V
4
kΩ
14
mW
Electrical and optical characteristics (Ta=25 °C, unless otherwise noted)
Parameter
Symbol
Min.
Typ.
Max.
Saturation output voltage
Vsat
-
Fw × Sv
-
Full well capacity
Vertical
Horizontal*⁵
240
320
-
Fw
800
1000
-
CCD node sensitivity
Sv
1.8
2.2
-
Dark current*⁶
(MPP mode)
Readout noise*⁷
25 °C
0 °C
-
100
400
DS
-
10
40
Nr
-
8
16
Dynamic range*⁸
Line binning
Area scanning
Photo response non-uniformity*⁹
100000
125000
-
DR
30000
40000
-
PRNU
-
±3
±10
Spectral response range
λ
-
200 to 1100
-
Point defect*^{10 White spots}
-
-
0
Black spots
-
-
10
Cosmetics
Cluster defect*¹¹
-
-
-
3
Column defect*¹²
-
-
0
*5: The linearity is ±1.5 %.
*6: Dark current nearly doubles for every 5 to 7 °C increase in temperature.
*7: Measured with a HAMAMATSU C4880 digital CCD camera with a CDS circuit (sensor temperature: -40 °C, operating frequency:
150 kHz)
*8: Dynamic range (DR) = Full well capacity / Readout noise
*9: Measured at one-half of the saturation output (full well capacity) using LED light (peak emission wavelength: 560 nm)
Unit
V
ke^-
μV/e^-
e^-/pixel/s
e^- rms
-
-
%
nm
-
-
-
-
Fixed pattern noise (peak to peak)
Photo response non-uniformity =
× 100 [%]
Signal
*10: White spots
Pixels whose dark current is higher than 1 ke- after one-second integration at 0 °C.
Black spots
Pixels whose sensitivity is lower than one-half of the average pixel output. (measured with uniform light producing one-half of the
saturation charge)
*11: 2 to 9 contiguous defective pixels
*12: 10 or more contiguous defective pixels
3