C9311DK Datasheet, PDF (2/6 Pages) Hamamatsu Corporation – Flat panel sensor High sensitivity, high-speed frame rate, high resolution

Flat panel sensor C9311DK
s G eneral ratings
Param eter
Pixel size
Photodiode area
Num ber of pixels
Num ber of active pixels
Readout
Video output (Data1 - 12)
Output data rate
Synchronous signal (Vsync, Hsync, Pclk)
ExtTrgGrb, ExtTrgLem o, IntExt, bin0, bin1
S c in tilla to r
S p e c ific a tio n
100 × 100
124.8 × 115.2
1248 × 1152
1232 × 1120
Charge am plifier array
LV D S (differential) 2-port, 12 -bit
33.333
LV D S (differential)
TTL
D irect deposition C sI
U n it
µm
mm
pixels
pixels
-
-
MHz
-
-
-
s A bsolu te m axim um ratings
Param eter
Supply voltage for digital circuitry (+5 V)
Supply voltage for analog circuitry (+5 V)
Input voltage (ExtTrgGrb, ExtTrgLem o,
bin1)
Operating tem perature *¹
Storage temperature *¹
*1: No condensation.
In tE xt,
bin0,
Sym bol
D .vd d
A .vd d
Vin
To p r
Ts tg
Va lu e
+6.0
+6.0
0 to 6.0
0 to +35
-10 to +50
U n it
V
V
V
°C
°C
s S pecification (T a=25 °C , A.vdd= 5.0 V, D .vdd= 5.0 V )
Param eter
Sym bol
M in .
Ty p .
Max.
U n it
Fram e rate (single operation)
Sf (int)
28.5
30
-
fram es/s
Fram e rate (anim ation 2 × 2 binning)
-
-
30
-
fram es/s
Fram e rate (fast 2 × 2 m ode)
-
-
88
-
fram es/s
Fram e rate external (single operation)
Sf (ext)
-
Sf (int) to 1
-
fram e/s
Noise (rm s) *²
N (rm s)
-
1500
-
electrons
Saturation charge
Csat
-
3.9
-
M electrons
Sensitivity *³
S
1600
2000
-
LSB/m R
R esolution *⁴
Reso
3.55
5
-
line pairs/m m
Dynam ic range
-
-
2600
-
-
Defect line *⁵
-
-
-
10
lines
O utput offset *⁶
-
-
65
200
LSB
*2: Internall trigger m ode, single operation
*3: 80 kVp, acrylic filter 170 m m .
*4: Spatial frequency at C TF=5 %
*5: A defective line is a vertical or horizontal line containing 4 or m ore consecutive pixels that produce less than 1/8 of the
average output from the surrounding pixels. In this case, one of the following conditions m ust be m et.
H orizontal defective line: D efective pixels are continuously located from the opposite side of the shift register on the upper
side or lower side.
Vertical defective line : D efective pixels are continuously located, starting from R ow 575 toward R ow 0 in the upper half
area.
D efective pixels are continuously located, starting from R ow 576 tow ard R ow 1151 in the low er
half area.
Adjacent defective lines are not allowed in the vertical and horizontal directions.
*6: Average of all effective pixels in single operation at Sf (int)
N ote: X-ray energy range is 20 k to 80 kVp.
s Resolution
(Ta=25 ˚C, A.vdd=5.0 V, D.vdd=5.0 V)
100
90
80
70
60
50
40
30
20
10
0
0
0.5
1
1.5
2
2.5
SPATIAL FREQUENCY (line pairs/mm)
KACCB0136EA
2