MB6 Datasheet, PDF (4/4 Pages) GREATECS – SMT Double Action Switch

Multi-Direction Switches
SMT Double Action Switch
MB6 Series
Measurements shall be made following 1 Operating force:±30% of
the test forth below烉
initial force
1 5mA,5 VDC resistive load
2 Contact Resistance:
2 Applying a static load the operating ^{10Ÿ Max}
11
Operating
Life
force to the center of the stem in the ^{3 Insulation Resistance:}
direction of operation
10MŸ Min
Static Load烌OF Max.
4 Bounce:
3 Cycle of Operation烉
30,000 cycles Min
20 m seconds max
5 Voltage: AC 250V 1minute
Min
Following the test set forth below
the sample shall be left in normal
Resistance ^{temperature and humidity}
12
Low ^{conditions for 1 hour before the}
Tempera- ture ^{measurements are made:}
1 Temperature:-30±2ɗ
2 Time: 96 hours
1 Contact Resistance:
10Ÿ Max
2 Insulation Resistance:
10MŸ Min
3 Bounce:
20 m seconds max
4 Voltage: AC 250V 1minute
Min
Following the test set forth below the
sample shall be left in normal
temperature and humidity conditions
13
Heat for 1 hour before the measurements
Resistance ^{are made:}
1 Temperature:85±2ɗ
2 Time: 96 hours
Ditto
14
Humidity
Resistance
Following the test set forth below
the sample shall be left in normal
temperature and humidity
conditions for 1 hour before the
measurements are made:
1 Temperature:40±2ɗ
2 Relative Humidity: 90~95%
3 Time: 96 hours
Ditto
5. SOLDERING CONDITIONS:
Ŷ Reflowl Soldering
MAX 260°C
255°C
230°C
150°C
Room
Temperature
120~150sec
TIME(sec)
5~10sec
60sec
H01 [e-mail]
Ŷ Manual Soldering
Soldering Temperature
Continuous Soldering Time
Max. 350 °C
Max. 5 seconds
www.greatecs.com 4