N010-0554-T902 Datasheet, PDF (5/7 Pages) Fujitsu Component Limited. – STANDARD Resistive Touch Panel Specification

554 SERIES
n 7.0 REJECT CRITERIA
Description
Reject Criteria
Film Dent
Area ≥ 0.1mm²
Area ≥ 0.05mm² & area < 0.1mm²
Area < 0.05mm²
: to be zero
: to be max. 5 points
: none specified
Foreign
material
between
glass and film
Dot type
Line type
Area > 0.1mm²
Area ≥ 0.05mm² & area < 0.1mm²
Area < 0.05mm²
Area > 0.1mm
Area ≥ 0.03mm & width <0.1mm and length < 10mm
Area < 0.05mm
: to be zero
: to be max. 5 points
: none specified
: to be zero
: to be max. 1 point
: none specified
Scratch
Area ≥ 0.1mm
: to be zero
Area ≥ 0.03mm & width <0.1mm with length < 80mm : to be max. 1 point
Area < 0.03mm & width <0.1mm with length < 30mm : none specified
Dot blur or hard coat
missing
Area ≥ 0.5mm²
Area ≥ 0.03mm² & area < 0.5mm²
Area < 0.05mm²
: to be zero
: to be max. 5 points
: none specified
Newton Ring
These must not be seen from Panel film side under a fluorescent lamp (3
wavelength type lamp). Not to be verified form glass side.
Glass flaw
To be no flaw which is bigger than that shown in the following diagram. The
number of flaws is not specified.
3mm
2mm
5mm
2mm
n 8.0 GENERAL POINTS OF CAUTION
Touch panels are made of glass, so care must be taken in handling them. Do not stress, pile, bend, lift by
the cable or put any stress on the film, for example moving by film face vacuum. In order to clean wring dry a
cloth which has been emersed in a natural detergent. DO NOT use any organic solvent, acid or alkali solu-
tion. Watch the edge of the panel when cleaning, again for safety reasons.