N010-0554-T902 Datasheet, PDF (2/7 Pages) Fujitsu Component Limited. – STANDARD Resistive Touch Panel Specification

n DIMENSION EXAMPLE (10.4” SHOWN)
(8.00)
(8.70)
9.50 Anti-input area
(10.00)
554 SERIES
228.20
216.20: Transparent area
214.80: Boundary line of the top enclosure
213.20
212.20: Guaranteed active area
112.10
Top
4.00
4.70
5.50 Anti-input area
6.00
10.20
26.50
Left
Right
75.00±1.0
Bottom
n DETAILED SPECIFICATION
n 1.0 APPLICATION
This specification applies to the standard FID-554 seriesTouch Panel (Pen/Finger type).
Unit: mm
n 2.0 ADDITIONAL APPLICATIONS
Complete specification document is available upon request for customers with whom we have an approved
NDA in place.
n 3.0 DESCRIPTION AND BLOCK DIAGRAM
This panel in combination with a control IC chip is used to transfer the co-ordinates of the touched position to
the host system (see block diagram above).
n 4.0 DRAWING (Please see the diagram above.)
Definitions of the major dimensions indicated on this diagram:
A
Effective Input Area (A)
Area guaranteed to meet all the B

characteristics detailed in this specification
Anti-input Area (C)
An insulating area allowed to protect


trheeadtoinugcshwphaennelafnroemncgliovsinugrefatolsuec _{hes C}

the panel. (See fixing instructions)
n 5.0 CHARACTERISTICS
n 5.1 MECHANICAL
Force
Operating Force
0.05~0.49 N (5 ~ 50gF) Measured with

a Silicon Measurement Rod R 8

(Round type 8mm) Silicon Rubber

Hardness 60˚C
Hardness of Surface Pencil hardness 3H minimum against

specification JIS K-5400
Silicon Rubber Rod
n 5.2 OPTICAL
Transparency

Haze

78% min. measured in the effective input area to JIS K 7105 using a
MURAKAMI SHIKISAI KENKYUSHO type IIR 100 meter.
5% type measured in the effective input area using a MURAKAMI
SHIKISAI KENKYUSHO type IIR 100 meter with an Anti Glare treated