MB85RS128A Datasheet, PDF (10/20 Pages) Fujitsu Component Limited. – Memory FRAM 128K (16 K x 8) Bit SPI

MB85RS128A
■ BLOCK PROTECT
Writing protect block is configured by the WRITE command with BP1, BP0 value of the status register.
BP1
BP0
Protected Block
0
0
None
0
1
3000H to 3FFFH (upper 1/4)
1
0
2000H to 3FFFH (upper 1/2)
1
1
0000H to 3FFFH (all)
■ WRITING PROTECT
Writing operation of the WRITE command and the WRSR command are protected with the value of WEL,
WPEN, WP as shown in the table.
WEL
WPEN
WP
Protected Blocks Unprotected Blocks
Status Register
0
X
X
Protected
Protected
Protected
1
0
X
Protected
Unprotected
Unprotected
1
1
0
Protected
Unprotected
Protected
1
1
1
Protected
Unprotected
Unprotected
■ HOLD OPERATION
Hold status is retained without aborting a command if HOLD is “L” while CS is “L”. The timing for starting
and ending hold status depends on the SCK to be “H” or “L” when a HOLD pin input is transited as shown
in the diagram below. Arbitrary command operation is interrupted in hold status, SCK and SI inputs become
don’t care. And, SO becomes High-Z while reading command (RDSR, READ) . If CS is risen with hold status,
a command is aborted and device is reset.
CS
SCK
HOLD
Hold Condition
Hold Condition
10
DS501-00008-0v01-E