MC9S08JS16 Datasheet, PDF (6/32 Pages) Freescale Semiconductor, Inc – Technical Data

Electrical Characteristics
3 Electrical Characteristics
This chapter contains electrical and timing specifications.
3.1 Parameter Classification
The electrical parameters shown in this supplement are guaranteed by various methods. To give the
customer a better understanding, the following classification is used and the parameters are tagged
accordingly in the tables where appropriate:
Table 2. Parameter Classifications
P Those parameters are guaranteed during production testing on each individual device.
C Those parameters are achieved by the design characterization by measuring a
statistically relevant sample size across process variations.
T Those parameters are achieved by design characterization on a small sample size from
typical devices under typical conditions unless otherwise noted. All values shown in the
typical column are within this category.
D Those parameters are derived mainly from simulations.
NOTE
The above classifications are used in the column labeled “C” in applicable
tables of this data sheet.
3.2 Absolute Maximum Ratings
Absolute maximum ratings are stress ratings only, and functional operation at the maximum is not
guaranteed. Stress beyond the limits specified in Table 3 may affect device reliability or cause permanent
damage to the device. For functional operating conditions, refer to the remaining tables in this section.
This device contains circuitry protecting against damage due to high static voltage or electrical fields;
however, it is advised that normal precautions be taken to avoid application of any voltages higher than
maximum-rated voltages to this high-impedance circuit. Reliability of operation is enhanced if unused
inputs are tied to an appropriate logic voltage level (for instance, either V_SS or V_DD).
Table 3. Absolute Maximum Ratings
Rating
Supply voltage
Input voltage
Instantaneous maximum current
(applies to all port pins)^{1, 2, 3}
Maximum current into V_DD
Storage temperature
Maximum junction temperature
Single pin limit
Symbol
Value
Unit
V_DD
V_In
2.7 to 5.5
V
–0.3 to V_DD + 0.3
V
I_D
±25
mA
I_DD
T_stg
T_J
120
mA
–55 to 150
°C
150
°C
MC9S08JS16 Series MCU Data Sheet, Rev. 4
6
Freescale Semiconductor