MC9S08AW32CPUE Datasheet, PDF (291/324 Pages) Freescale Semiconductor, Inc – Microcontrollers

Appendix A Electrical Characteristics and Timing Specifications
A.7 Supply Current Characteristics
Table A-8. Supply Current Characteristics
Num C
Parameter
2
Run supply current measured at
1
P
(CPU clock = 2 MHz, f_Bus = 1 MHz)
Run supply current² measured at
2
P
(CPU clock = 16 MHz, f_Bus = 8 MHz)
Run supply current³ measured at (CPU
3
P _{clock = 40 MHz, fBus = 20 MHz)}
Stop2 mode supply current
4P
Symbol
RI_DD
RI_DD
RI_DD
S2I_DD
V_DD
(V)
Typ¹
5 0.750
3 0.570
5 4.90
3 3.50
5 16.8
3 11.5
5 0.900
3 0.720
Max
0.950
0.770
5.10
3.70
18.5
12.5
18.0
60
17.0
50
Unit
Temp
(°C)
mA –40 to 125°C
mA –40 to 125°C
mA –40 to 125°C
–40 to 85°C
μA –40 to 125°C
–40 to 85°C
μA –40 to 125°C
Stop3 mode supply current
5P
S3I_DD
20.0
5 0.975 90
19.0
3 0.825 85
–40 to 85°C
μA –40 to 125°C
–40 to 85°C
μA –40 to 125°C
6
C ^{RTI adder to stop2 or stop34}
5
300
500
500
nA
–40 to 85°C
–40 to 125°C
S23I
DDRTI
3
300
500
500
nA
–40 to 85°C
–40 to 125°C
5
110
180
μA –40 to 125°C
7
C LVD adder to stop3 (LVDE = LVDSE = 1) S3I_DDLVD
3
90
160
μA –40 to 125°C
Adder to stop3 for oscillator enabled
8
C _{(OSCSTEN =1)5}
S3I_DDOSC
5,3
5
8
μA –40 to 125°C
1 _{Typical values are based on characterization data at 25°C unless otherwise stated. See Figure A-5 through Figure A-7 for}
typical curves across voltage/temperature.
2 _{All modules except ADC enabled, but not active. ICG configured for FBE. Does not include any DC loads on port pins.}
3 _{All modules except ADC active, ICG configured for FBE and does not include any DC loads on port pins}
4 _{Most customers are expected to find that auto-wakeup from stop2 or stop3 can be used instead of the higher current wait}
mode. Wait mode typical is 500 μA at 5 V with f_Bus = 1 MHz.
5 _{Values given under the following conditions: low range operation (RANGE = 0) with a 32.768 kHz crystal, low power mode}
(HGO = 0), clock monitor disabled (LOCD = 1).
MC9S08AW60 Data Sheet, Rev 2
Freescale Semiconductor
291