MPXV5050VC6T1 Datasheet, PDF (2/8 Pages) Freescale Semiconductor, Inc – High Temperature Accuracy Integrated Silicon Pressure Sensor On-Chip Signal Conditioned, Temperature Compensated and Calibrated

Table 1. Maximum Ratings⁽¹⁾
Rating
Symbol
Value
Maximum Pressure (P1 > P2)
P_max
200
Storage Temperature
T_stg
–40° to +125°
Operating Temperature
T_A
–40° to +125°
1. Exposure beyond the specified limits may cause permanent damage or degradation to the device.
Units
kPa
°C
°C
Table 2. Operating Characteristics (V_S = 5.0 Vdc, T_A = 25°C unless otherwise noted, P1 > P2.)
Characteristic
Symbol
Min
Typ
Max
Unit
Pressure Range
P_OP
–50
—
0
kPa
Supply Voltage⁽¹⁾
V_S
4.75
5.0
5.25
Vdc
Supply Current
I_o
—
7.0
10
mAdc
Full Scale Output⁽²⁾
@ V_S = 5.0 Volts
(0 to 85°C)
V_FSO
4.488
4.6
4.713
Vdc
(P_diff = 0 kPa)
Full Scale Span⁽³⁾
@ V_S = 5.0 Volts
(0 to 85°C)
V_FSS
—
4.5
—
Vdc
Accuracy⁽⁴⁾
(0 to 85°C)
—
—
—
±2.5
%V_FSS
Sensitivity
V/P
—
90
—-
mV/kPa
Response Time⁽⁵⁾
t_R
—
1.0
—-
ms
Warm-Up Time⁽⁶⁾
—
—
20
—-
ms
Offset Stability⁽⁷⁾
—
—
± 0.5
—-
%V_FSS
Pressure Offset⁽⁸⁾
(0 to 85°C)
V_off
0
0.1
0.213
Vdc
1. Device is ratiometric within this specified excitation range.
2. Full Scale Output (V_FSO) is defined as the output voltage at the maximum or full rated pressure.
3. Full Scale Span (V_FSS) is defined as the algebraic difference between the output voltage at full rated pressure and the output voltage at the
minimum rated pressure.
4. Accuracy is the deviation in actual output from nominal output over the entire pressure range and temperature range as a percent of span
at 25°C due to all sources of errors, including the following:
• Linearity:
Output deviation from a straight line relationship with pressure over the specified pressure range.
• Temperature Hysteresis: Output deviation at any temperature within the operating temperature range, after the temperature is cycled to
and from the minimum or maximum operating temperature points, with zero differential pressure applied.
• Pressure Hysteresis:
Output deviation at any pressure within the specified range, when this pressure is cycled to and from minimum
or maximum rated pressure at 25°C.
• TcSpan:
Output deviation over the temperature range of 0° to 85°C, relative to 25°C.
• TcOffset:
Output deviation with minimum pressure applied, over the temperature range of 0° to 85°C, relative to 25°C.
5. Response Time is defined as the time for the incremental change in the output to go from 10% to 90% of its final value when subjected to a
specified step change in pressure.
6. Warm-up Time is defined as the time required for the product to meet the specified output voltage after the pressure has been stabilized.
7. Offset Stability is the product's output deviation when subjected to 1000 hours of Pulsed Pressure, Temperature Cycling with Bias Test.
8. Offset (V_off) is defined as the output voltage at the minimum rated pressure.
MPXV5050VC6T1
2
Sensors
Freescale Semiconductor