MC9S08SE8 Datasheet, PDF (1/38 Pages) Freescale Semiconductor, Inc – 8-Bit HCS08 Central Processor Unit

Freescale Semiconductor
Data Sheet: Technical Data
Document Number: MC9S08SE8
Rev. 3, 4/2009
MC9S08SE8
28-Pin SOIC
TBD ^{Case 751F}
16-Pin TSSOP
Case 948F-01
MC9S08SE8 Series
Covers: MC9S08SE8
MC9S08SE4
Features:
• 8-Bit HCS08 Central Processor Unit (CPU)
– 20 MHz HCS08 CPU (central processor unit)
– 10 MHz internal bus frequency
– HC08 instruction set with added BGND
– Support for up to 32 interrupt/reset sources
• On-Chip Memory
– Up to 8 KB of on-chip in-circuit programmable flash
memory with block protection and security options
– Up to 512 bytes of on-chip RAM
• Power-Saving Modes
– Wait plus two stops
• Clock Source Options
– Oscillator (XOSC) — Loop-control Pierce oscillator;
crystal or ceramic resonator range of 31.25 kHz to
38.4 kHz or 1 MHz to 16 MHz
– Internal Clock Source (ICS) — Internal clock source
module containing a frequency-locked-loop (FLL)
controlled by internal or external reference; precision
trimming of internal reference allows 0.2% resolution
and 2% deviation over temperature and voltage;
supports bus frequencies from 1 MHz to 10 MHz.
• System Protection
– Optional computer operating properly (COP) reset with
option to run from independent 1 kHz internal clock
source or the bus clock
– Low voltage detection
– Illegal opcode detection with reset
– Illegal address detection with reset
• Development Support
– Single-wire background debug interface
– Breakpoint capability to allow single breakpoint setting
during in-circuit debugging
• Peripherals
28-Pin PDIP
Case 710-02
– SCI — Full duplex non-return to zero (NRZ); LIN
master extended break generation; LIN slave extended
break detection; wakeup on active edge
– ADC — 10-channel, 10-bit resolution; 2.5 μs
conversion time; automatic compare function;
1.7 mV/°C temperature sensor; internal bandgap
reference channel; runs in stop3
– TPMx — One 2-channel (TPM1) and one 1-channel
(TPM2) 16-bit timer/pulse-width modulator (TPM)
modules; selectable input capture, output compare, and
edge-aligned PWM capability on each channel; timer
module may be configured for buffered, centered PWM
(CPWM) on all channels
– KBI — 8-pin keyboard interrupt module
– RTC — Real-time counter with binary- or
decimal-based prescaler
• Input/Output
– Software selectable pullups on ports when used as inputs
– Software selectable slew rate control on ports when used
as outputs
– Software selectable drive strength on ports when used as
outputs
– Master reset pin and power-on reset (POR)
– Internal pullup on RESET, IRQ, and BKGD/MS pins to
reduce customer system cost
• Package Options
– 28-pin PDIP
– 28-pin SOIC
– 16-pin TSSOP
This document contains information on a product under development. Freescale reserves the
right to change or discontinue this product without notice.
© Freescale Semiconductor, Inc., 2008-2009. All rights reserved.