MC9S08PA60 Datasheet, PDF (1/35 Pages) Freescale Semiconductor, Inc – MC9S08PA60 Series

Freescale Semiconductor
Data Sheet: Technical Data
MC9S08PA60 Series
Support: MC9S08PA60 and
MC9S08PA32
Key features
• 8-Bit S08 central processor unit (CPU)
– Up to 20 MHz bus at 2.7 V to 5.5 V across
temperature range of -40 °C to 105 °C
– Supporting up to 40 interrupt/reset sources
– Supporting up to four-level nested interrupt
– On-chip memory
– Up to 60 KB flash read/program/erase over full
operating voltage and temperature
– Up to 256 byte EEPROM; 2-byte erase sector;
program and erase while executing flash
– Up to 4096 byte random-access memory (RAM)
– Flash and RAM access protection
• Power-saving modes
– One low-power stop mode; reduced power wait
mode
– Peripheral clock enable register can disable
clocks to unused modules, reducing currents;
allows clocks to remain enabled to specific
peripherals in stop3 mode
• Clocks
– Oscillator (XOSC) - loop-controlled Pierce
oscillator; crystal or ceramic resonator range of
31.25 kHz to 39.0625 kHz or 4 MHz to 20 MHz
– Internal clock source (ICS) - containing a
frequency-locked-loop (FLL) controlled by
internal or external reference; precision
trimming of internal reference allowing 1%
deviation across temperature range of 0 °C to
70 °C and 2% deviation across temperature
range of -40 °C to 105 °C; up to 20 MHz
• System protection
– Watchdog with independent clock source
– Low-voltage detection with reset or interrupt;
selectable trip points
– Illegal opcode detection with reset
– Illegal address detection with reset
Document Number: MC9S08PA60
Rev. 1, 10/9/2012
MC9S08PA60
• Development support
– Single-wire background debug interface
– Breakpoint capability to allow three breakpoints
setting during in-circuit debugging
– On-chip in-circuit emulator (ICE) debug module
containing two comparators and nine trigger
modes
• Peripherals
– ACMP - one analog comparator with both
positive and negative inputs; separately
selectable interrupt on rising and falling
comparator output; filtering
– ADC - 16-channel, 12-bit resolution; 2.5 µs
conversion time; data buffers with optional
watermark; automatic compare function;
internal bandgap reference channel; operation
in stop mode; optional hardware trigger
– CRC - programmable cyclic redundancy check
module
– FTM - three flex timer modulators modules
including one 6-channel and two 2-channel
ones; 16-bit counter; each channel can be
configured for input capture, output compare,
edge- or center-aligned PWM mode
– IIC - One inter-integrated circuit module; up to
400 kbps; multi-master operation;
programmable slave address; supporting
broadcast mode and 10-bit addressing;
supporting SMBUS and PMBUS
– MTIM - Two modulo timers with 8-bit prescaler
and overflow interrupt
– RTC - 16-bit real timer counter (RTC)
– SCI - three serial communication interface (SCI/
UART) modules optional 13-bit break; full
duplex non-return to zero (NRZ); LIN extension
support
– SPI - one 8-bit and one 16-bit serial peripheral
interface (SPI) modules; full-duplex or single-
wire bidirectional; master or slave mode
Freescale reserves the right to change the detail specifications as may be
required to permit improvements in the design of its products.
© 2011–2012 Freescale Semiconductor, Inc.