V23836-C18-R363 Datasheet, PDF (8/13 Pages) Finisar Corporation. – 1x9 RoHS Compliant Transceiver with Duplex SC Receptacle Single Mode 1310 nm 21 km SONET OC-3/SDH STM-1

V23836-C18-R363 Product Specification – October 2006
Receiver Electro-Optical Characteristics
Parameter
Symbol
Sensitivity (Average Power)¹⁾
5V
3.3 V
Saturation (Average Power)
Signal Detect Assert Level²⁾
Signal Detect Deassert Level³⁾
Signal Detect Hysteresis
Signal Detect Assert Time
Signal Detect Deassert Time
Output Low Voltage⁴⁾
Output High Voltage⁴⁾
Output Data Rise/Fall Time, 20% - 80%
Output SD Rise/Fall Time
P_IN
P_SAT
P_SDA
P_SDD
P_SDA–P_SDD
t_ASS
t_DAS
V_OL–V_CC
V_OH–V_CC
t_R, t_F
Values
Unit
min. typ. max.
dBm
–36 –28
–31
–8
dBm
–34 dBm
–44
dBm
1
25
dB
75 100 µs
80 350 µs
–2000
–1580 mV
–1100
–740 mV
1.6
ns
10 40
ns
Notes:
1) Minimum average optical power at which the BER is less than 1x10^–10 or lower. Measured with a 2²³â€“1 NRZPRBS as
recommended by ANSI T1E1.2, SONET OC-3 and ITU-T G.957. BOL value –31 dBm max.
2) An increase in optical power of data signal above the specified level will cause the Signal Detect to switch from a low state to a
high state.
3) A decrease in optical power of data signal below the specified level will cause the Signal Detect to switch froma high state to a low
state.
4) DC/DC, PECL for Signal Detect, PECL compatible. Load is 50Ω into V_CC–2 V for data, 510 Ω to V_EE for SignalDetect. Measured
under DC conditions. For dynamic measurements a tolerance of 50 mV should be added.V_CC = 3.3 V. T_AMB = 25°C.
© Finisar Corporation October 2006 Rev. A Preliminary Data
8