MN35 Datasheet, PDF (5/10 Pages) Extech Instruments Corporation. – Manual Ranging Mini MultiMeter

Continuity Check Audible signal will sound if the resistance is less than
approximately <40Ω ± 5Ω
Temperature sensor Requires type K thermocouple
Input Impedance 10MΩ (VDC) and 4.5MΩ (VAC)
Display
1999 count LCD
Overrange
“1 or -1” is displayed
Polarity
Automatic (no indication for positive polarity); Minus
(-) sign for negative polarity.
Measurement Rate 3 times per second, nominal
Low Battery
“ ” is displayed if battery voltage drops below
operating voltage
Batteries
Requires one 9V battery (NEDA 1604 or equivalent)
Fuses
mA range; 250mA/250V fast blow
Operating Temp
Storage Temp
10A range, no protection
32^oF to 104^oF (0^oC to 40^oC)
-4^oF to 140^oF (-20^oC to 60^oC)
Relative Humidity Maximum relative humidity 80% for temperatures up
to 31°C decreasing linearly to 50% relative humidity
at 40°C.
Operating Altitude 7000ft (2000 meters) maximum.
Weight
5.4 oz. (153g).
Size
5.43” x 2.83” x 1.5” (138mm x 72mm x 38mm)
Safety
For indoor use and in accordance with Overvoltage
Category II, Pollution Degree 2. Category II includes
local level, appliance, portable equipment, etc., with
transient overvoltages less than Overvoltage
Category III.
Symbols
•)))
mV, V
Ω, kΩ, MΩ
µA, mA, A
º_F, º_C
º
HOLD
AC (voltage)
DC (direct current or voltage)
Continuity and Diode test
millivolt, volt (voltage)
ohm, kilohm, megohm (resistance)
microamp, milliamp, Amp (current)
Degrees fahrenheit, centigrade (temperature)
Low battery
Display hold
5
MN35 V2.0 2/05