MN35 Datasheet, PDF (3/10 Pages) Extech Instruments Corporation. – Manual Ranging Mini MultiMeter

Safety
International Safety Symbols
This symbol, adjacent to another symbol or terminal, indicates
the user must refer to the manual for further information.
This symbol, adjacent to a terminal, indicates that, under normal
use, hazardous voltages may be present
Double insulation
Safety Precautions
1. Improper use of this meter can cause damage, shock, injury or death.
Read and understand this user manual before operating the meter.
2. Make sure any covers or battery doors are properly closed and ured.
3. Always remove the test leads before replacing the battery or fuses.
4. Inspect the condition of the test leads and the meter itself for any
damage before operating the meter. Repair any damage before use.
5. Do not exceed the maximum rated input limits.
6. Use great care when making measurements if the voltages are greater
than 25VAC rms or 35VDC. These voltages are considered a shock
hazard.
7. Always discharge capacitors and remove power from the device under
test before performing Diode, Resistance or Continuity tests.
8. Remove the battery from the meter if the meter is to be stored for long
periods.
9. To avoid electric shock, do not measure AC current on any circuit
whose voltage exceeds 250V AC.
Input Limits
Function
Maximum Input
VDC, VAC
600V DC/AC
Resistance, Diode, Continuity 500V DC/AC
mA DC
250mA DC
10A DC
10A DC (15sec. max every 15 min.)
3
MN35 V2.0 2/05