|
XRT75R03 Datasheet, PDF (87/92 Pages) Exar Corporation – THREE CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER ATTENUATOR | |||
|
◁ |
xr
THREE CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER ATTENUATOR
XRT75R03
REV. 1.0.7
BIT NUMBER
NAME
1
JA in Tx Path Ch_n
0
JA0 Ch_n
TYPE
R/W
R/W
DEFAULT
VALUE
DESCRIPTION
0
Jitter Attenuator in Transmit/Receive Path Select Bit:
This input pin is used to configure the Jitter Attenuator
(within Channel_n) to operate in either the Transmit or
Receive path, as described below.
0 - Configures the Jitter Attenuator (within Channel_n) to
operate in the Receive Path.
1 - Configures the Jitter Attenuator (within Channel_n) to
operate in the Transmit Path.
0
Jitter Attenuator Configuration Select Input - Bit 0:
Please see the description for Bit 2 (JA1 Ch_n).
9.0 DIAGNOSTIC FEATURES:
9.1 PRBS Generator and Detector:
The XRT75R03 contains an on-chip Pseudo Random Binary Sequence (PRBS) generator and detector for
diagnostic purpose. This feature is only available in Host mode. With the PRBSEN_n bit = â1â, the transmitter
will send out PRBS of 223-1 in E3 rate or 215-1 in STS-1/DS3 rate. At the same time, the receiver PRBS
detector is also enabled. When the correct PRBS pattern is detected by the receiver, the RNEG/LCV pin will go
âLowâ to indicate PRBS synchronization has been achieved. When the PRBS detector is not in sync the
PRBSLS bit will be set to â1â and RNEG/LCV pin will go âHighâ.
With the PRBS mode enabled, the user can also insert a single bit error by toggling âINSPRBSâ bit. This is
done by writing a â1â to INSPRBS bit. The receiver at RNEG/LCV pin will pulse âHighâ for one RxClk cycle for
every bit error detected. Any subsequent single bit error insertion must be done by first writing a â0â to
INSPRBS bit and followed by a â1â.
Figure 25 shows the status of RNEG/LCV pin when the XRT75R03 is configured in PRBS mode.
NOTE: In PRBS mode, the device is forced to operate in Single-Rail Mode.
FIGURE 26. PRBS MODE
RClk
RNEG/LCV
SYNC LOSS
PRBS SYNC
Single Bit Error
9.2 LOOPBACKS:
The XRT75R03 offers three loopback modes for diagnostic purposes. In Hardware mode, the loopback modes
are selected via the RLB_n and LLB_n pins. In Host mode, the RLB_n and LLB_n bits n the Channel control
registers select the loopback modes.
9.2.1 ANALOG LOOPBACK:
84
|
▷ |