XRT75R03 Datasheet, PDF (55/92 Pages) Exar Corporation – THREE CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER ATTENUATOR

xr
THREE CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER ATTENUATOR
XRT75R03
REV. 1.0.7
When the XRT75R03 is configured in Host mode, the following input pins,TxLEV_n, TAOS_n, RLB_n, LLB_n,
E3_n, STS-1/DS3_n, REQEN_n, JATx/Rx, JA0 and JA1 are disabled and must be connected to ground.
The Table 14 below illustrates the functions of the shared pins in either Host mode or in Hardware mode.
PIN NUMBER
66
67
68
69
71
TABLE 14: FUNCTIONS OF SHARED PINS
IN HOST MODE
CS
RxClkINV
SClk
TxClkINV
SDI
RxON
SDO
RxMON
INT
LOSMUT
IN HARDWARE MODE
NOTE: While configured in Host mode, the TxON_n input pins will be active if the TxON_n bits in the control register are set
to “1”, and can be used to turn on and off the transmit output drivers. This permits a system designed for
redundancy to quickly switch out a defective line card and switch-in the backup line card.
52