XRT94L33_3 Datasheet, PDF (75/801 Pages) Exar Corporation – -CHANNEL DS3/E3/STS-1 TO STS-3/STM-1 MAPPER - SONET REGISTERS

Rev222...000...000
2
1
0
XRT94L33
333---CCCHHHAAANNNNNNEEELLL DDDSSS333///EEE333///SSSTTTSSS---111 TTTOOO SSSTTTSSS---333///SSSTTTMMM---111 MMMAAAPPPPPPEEERRR ––– SSSOOONNNEEETTT RRREEEGGGIIISSSTTTEEERRRSSS
Telecom Bus # 2 R/W STS-1 Telecom Bus # 2 – Receive Parity Error Interrupt Enable
– Receive Parity
Error Interrupt
Enable
This READ/WRITE bit-field permits the user to either enable or disable the
“Receive Parity Error” Interrupt for STS-1 Telecom Bus – Channel 2. If the
user enables this interrupt, then STS-1 Telecom Bus – Channel 2 will
generate an interrupt anytime the “Receive STS-1 Telecom Bus” detects a
parity error within the incoming STS-1 data.
0 – Disables the “Receive Parity Error” Interrupt.
1 – Enables the “Receive Parity Error” Interrupt.
Note: This bit-field is only active if “STS-1 Telecom Bus – Channel 2” has
been enabled.
Telecom Bus # 1 R/W STS-1 Telecom Bus # 1 – Receive Parity Error Interrupt Enable
– Receive Parity
Error Interrupt
Enable
This READ/WRITE bit-field permits the user to either enable or disable the
“Receive Parity Error” Interrupt for STS-1Telecom Bus – Channel 1. If the
user enables this interrupt, then STS-1 Telecom Bus – Channel 1 will
generate an interrupt anytime the “Receive STS-1 Telecom Bus” detects a
parity error within the incoming STS-1 data.
0 – Disables the “Receive Parity Error” Interrupt.
1 – Enables the “Receive Parity Error” Interrupt.
Note: This bit-field is only active if “STS-1 Telecom Bus – Channel 1” has
been enabled.
Telecom Bus # 0 R/W STS-1 Telecom Bus # 0 – Receive Parity Error Interrupt Enable
– Receive Parity
Error Interrupt
Enable
This READ/WRITE bit-field permits the user to either enable or disable the
“Receive Parity Error” Interrupt for STS-1 Telecom Bus – Channel 0. If the
user enables this interrupt, then STS-1 Telecom Bus – Channel 0 will
generate an interrupt anytime the “Receive STS-1 Telecom Bus” detects a
parity error within the incoming STS-1 data.
0 – Disables the “Receive Parity Error” Interrupt.
1 – Enables the “Receive Parity Error” Interrupt.
Note: This bit-field is only active if “STS-1 Telecom Bus – Channel 0” has
been enabled.
75