XR16V2650_07 Datasheet, PDF (1/47 Pages) Exar Corporation – HIGH PERFORMANCE DUART WITH 32-BYTE FIFO

XR16V2650
HIGH PERFORMANCE DUART WITH 32-BYTE FIFO
MAY 2007
REV. 1.0.2
GENERAL DESCRIPTION
The XR16V2650¹ (V2650) is a high performance dual
universal asynchronous receiver and transmitter
(UART) with 32 bytes TX and RX FIFOs. The device
operates from 2.25 to 3.6 volts with 5 Volt tolerant
inputs and is pin-to-pin compatible to Exar’s
ST16C2550, XR16C2550 and XR16V2550. The
V2650 register set is compatible to the ST16C2550,
the XR16L2550 and the XR16V2550. It supports
Exar’s enhanced features of selectable FIFO trigger
level, automatic hardware (RTS/CTS) and software
flow control, and a complete modem interface.
Onboard registers provide the user with operational
status and data error flags. An internal loopback
capability allows system diagnostics. Independent
programmable baud rate generators are provided in
each channel to select data rates up to 16 Mbps at
3.3 Volt with 4X sampling clock. The V2650 is
available in 48-pin TQFP and 32-pin QFN packages.
NOTE: 1 Covered by U.S. Patent #5,649,122
APPLICATIONS
• Portable Appliances
• Telecommunication Network Routers
• Ethernet Network Routers
• Cellular Data Devices
• Factory Automation and Process Controls
FEATURES
• 2.25 to 3.6 Volt Operation
• 5 Volt Tolerant Inputs
• Pin-to-pin compatible to ST16C2550, XR16C2550,
XR16L2550 and XR16V2550 in the 48-TQFP
package
• Two independent UART channels
■ Register set compatible to XR16V2550
■ Data rate of up to 16 Mbps at 3.3 V, and 12.5
Mbps at 2.5 V with 4X sampling rate
■ Fractional Baud Rate Generator
■ Transmit and Receive FIFOs of 32 bytes
■ Selectable TX and RX FIFO Trigger Levels
■ Automatic Hardware (RTS/CTS) Flow Control
■ Automatic Software (Xon/Xoff) Flow Control
■ Wireless Infrared (IrDA 1.0) Encoder/Decoder
■ Automatic sleep mode
■ Full modem interface
• Device Identification and Revision
• Crystal oscillator (up to 32MHz) or external clock
(up to 64MHz) input
• 48-TQFP and 32-QFN packages
FIGURE 1. XR16V2650 BLOCK DIAGRAM
A2:A0
D7:D0
IOR#
IOW#
CSA#
CSB#
INTA
INTB
TXRDYA#
TXRDYB#
RXRDYA#
RXRDYB#
Reset
8-bit Data
Bus
Interface
* 5 Volt Tolerant Inputs
UART Channel A
UART ^{32 Byte TX FIFO}
Regs
TX & RX
IR
ENDEC
BRG _{32 Byte RX FIFO}
UART Channel B
(same as Channel A)
Crystal Osc/Buffer
2.25 to 3.6 Volt VCC
GND
TXA, RXA, DTRA#,
DSRA#, RTSA#,
DTSA#, CDA#, RIA#,
OP2A#
TXB, RXB, DTRB#,
DSRB#, RTSB#,
CTSB#, CDB#, RIB#,
OP2B#
XTAL1
XTAL2
Exar Corporation 48720 Kato Road, Fremont CA, 94538 • [phone] • FAX [phone] • www.exar.com