M10477 Datasheet, PDF (9/29 Pages) List of Unclassifed Manufacturers – GPS RADIONOVA® RF Antenna Module

®
m2m
Bill of Material
GPS RADIONOVA^® RF Antenna Module
Part No. M10477
Designator
Value
Description/Comments
Quantity
U1
SST25WF040-
40-51-QAE
SST serial flash memory 4MB
1
C1, L1, L2
C3, C4, C5
T _C2
F _C6
R1, R2, R3
TBD
22pF capacitor
2.2uF capacitor
0.1uF capacitor
10K resistor
Dependant on device matching circuit
Decoupling capacitor. Place close to corresponding pin
Decoupling capacitor. Place close to corresponding pin
Decoupling capacitor. Place close to corresponding pin
Used for Pull up/Down
TBD
3
1
1
3
RA _{Host Port Selection Straps}
The host interface is selected with hardware setup. The table below shows the configuration that determines
D _{the interface used. The interface cannot be changed dynamically after start-up.}
Interface
Y _SPI
UART
R _I2C
Pin 9 (CLK_CTS)
Leave Floating
10K PU to VCC
Leave Floating
Pin 10 (CS_RTS)
Leave Floating
Leave Floating
10K PU to VCC
INA ^{Host Baud Rate/Protocol Selection}
With the GSD4e 9333 chip the default baud rate and output protocol is user configurable at start-up with a
hardware configuration. This is limited to the values in the following table.
If using the I²C interface for external sensor or external memory, then these pins cannot be used for
IM configuration of the Baud rate or protocol. This means that the module will return to a default setting for UART
of 4800 baud.
L _{The baud rate and output protocol can be changed dynamically after start up using the relevant commands.}
Please contact Antenova for more information about protocol messages.
E _{Hardware Baud Rate Selection Table}
R_{Baud Rate}
P₄₈₀₀
Pin18 (DR_I2C_DIO)
PU
Pin 19 (DR_I2C_CLK)
PU
9600
PU
PD
38400
PD
PU
115200 (OSP)
PD
PD
PU = Pull up resistor to VCC (10K Ω)
PD = Pull down resistor to GND (10K Ω)
Antennas for Wireless M2M Applications

Product Specification 12MD-0049-0.6-PS