JKXFD1G05MCSM Datasheet, PDF (9/10 Pages) List of Unclassifed Manufacturers – Wire gauge range from 28 AWG to 14 AWG

JKX Series
Wiring and assembly instructions
• Collets selection according to cable diameters
3 or 5 collets per shell size allow a wide range of cable diameters for a single connector. Cable out diameters are for information
only, since values will change with each cable construction.
21
4
6
3
5
Collet number
1
2
3
4
5
Shell size 0
1.5 - 2.5
2.6 - 3.5
3.6 - 4.5
-
-
Cable diameter
Size 0, option G Shell size 1
-
2 - 2.5
-
2.6 - 3.5
-
3.6 - 4.5
4.6 - 5.5
4.6 - 5.5
5.6 - 6
5.6 - 6
Size 1, option G
-
-
6.1 - 6.7
6.8 - 7.7
7.8 - 8
Collet number 4 in shell size 0 and collet number 6 in shell size 1 are not used.
• Cable seal selections according to cable size
Cable gland
ØA
2
3.5
2.5
4
ØA
5.5
7
Discreet application based on cable diameter
Shell size 0
1.5 - 2.9
3 - 4.5
Cable diameter
Size 0, option G Shell size 1
4.6 - 4.9
5-6
2 - 3.4
3.5 - 4.9
5-6
Size 1, option G
-
-
6.1 - 6.4
6.5 - 8
• Shielding
Tested according to MIL-STD 1344 A, method 3007
Shell size
Electrical
continuity (mΩ)
0
4
mV
G
A
1
3
• Coupling torques
Advised torque* in Nm
Size
0
0
1
mm
(option G)
1.6
/
1.8
1
(option G)
/
Tool dimensions
Tools
(jaw dimensions)
Size
14 x 1
0
0
(option G)
17
16 x 1
1
1
(option G)
19
1.5
2
2
2.5
8
10
13
0.8
0.8
1
1
10
11
12
14
Torque values are the maximum allowable for each connector size.
Torque values will vary due to the type and size of the cable used
*Apply thread lock to back nut prior to assembly.
Tool numbers can be found on page 32
39