JKXFD1G05MCSM Datasheet, PDF (8/10 Pages) List of Unclassifed Manufacturers – Wire gauge range from 28 AWG to 14 AWG

JKX Series
Wiring and assembly
instructions :
STRAIGHT PLUG
• Cable stripping : see page 37
• Connector preparation
• Contacts wiring : crimp contacts
• Contacts wiring : solder contacts
1 - Select the proper collet ➃ and the cable
seal ➂ (see page 39).
2 - Slide protective boot ➅, the backnut ➄, the
collet ➃, the cable seal ➂, the outershell ➁
and the taper seat ➀ onto the cable. Strip end
of cable (see pg. 16)
1 - Select the proper crimping tool (see page 48)
2 - Adjust the crimping tool based on the wire
size “AWG”. (See wire size and crimp tool
settings on the back of this locator.)
3 - Crimp the contacts ➃ then insert the contact
into the insulator until the clip is fully seated
and cannot be removed.
Fixed solder contacts 0.5 mm and 0.7 mm
Removable solder contacts from 0.9 mm to 1.3 mm
1 - Insert wire into solder cup and solder
• Connector assembly
1 - Insert wire into solder cup and solder
2 - Insert the contact into the insulator until the clip is fully seated and cannot be removed.
1 - In case of shielded cable, comb out the shield
and fold back over the tapper seat ➀.
2 - Position 2 half bushes ➈, making sure that the
insert key appears through the windows of one
bush.
3 - Position the taper seat ➀ on the half bushes ➈.
4 - Position all the sub-assembly in connector
housing ➉, making sure to keep the sub-
assembly well aligned.
5 - Screw the outershell ➁ following the torque
values on page 39. Install the cable seal ➂ and
the collet ➃ into the outershell ➁ then screw
the backnut ➄ till bottoming. Use 2 wrenches
well positionned on the flats A and B. Place a
wrench to grip flats B, use the other wrench to
tighten the backnut at the flats A following the
torque values on page 39.
6 - Install the protective boot ➅ if applicable.
38