TS55001 Datasheet, PDF (8/22 Pages) List of Unclassifed Manufacturers – High Efficiency Li-Ion Battery Charger

TS55001
Version 1.3
FUNCTIONAL DESCRIPTION
The TS55001 is a fully-integrated Li-Ion battery charger IC based on a highly-efficient switching topology. It includes
configurability for termination voltage, charge current and a host of other variables to allow optimum charging conditions for a
wide range of Li-Ion batteries. A 1 MHz internal switching frequency facilitates low-cost LC filter combinations.
When the battery voltage is below 3.0 volts, the device will enter a pre-charge state and apply a small, programmable charge
current to safely charge the battery to a level for which full charge current can be applied. Once the full charge mode has been
initiated, the regulation will be constant current (CC).
When the battery voltage has increased enough to go into maintenance mode, the PWM control loop will force a constant
voltage across the battery. Once in constant voltage mode, current is monitored to determine when the battery is fully charged.
This regulation voltage as well as the 1C charging current can be set to change based on battery temperature. There are 4
temperature ranges where these can be set independently, 0-10°C, 10-45°C, 45-50°C and 50-60°C. The 0°C and 60°C thresholds
will stop charging and have 10 degrees of hysteresis. The intermediate points have 1 degree of hysteresis.
INTERNAL PROTECTION DETAILS
Internal Current Limit
The current through the inductor is sensed on a cycle by cycle basis and if current limit is reached, it will abbreviate the cycle.
Current limit is always active when the regulator is enabled.
Thermal Shutdown
If the temperature of the die exceeds 170°C (typical), the SW outputs will tri-state to protect the device from damage. The nFLT
and all other protection circuitry will stay active to inform the system of the failure mode. Once the device cools to 160°C
(typical), the device will attempt to start up again. If the device reaches 170°C, the shutdown/restart sequence will repeat.
VIN Under-Voltage Lockout
The device is held in the off state until VIN reaches 3.15V. There is a 200mV hysteresis on this input, which requires the input
to fall below 2.95V before the device will disable.
Battery Over-Voltage Protection
The TS55001 has a battery protection circuit designed to shutdown the charging profile if the battery voltage is greater than
the termination voltage. The termination voltage can change based on user programming, so the protection threshold is set to
2% above the termination voltage. Shutting down the charging profile puts the TS55001 in a fault condition.
FAULT HANDLING
nFLT Pin Functionality
In the event of a battery over-voltage, the battery temperature being outside of the safe charging range or the full charge timer
expiring, charging will stop, and the nFLT pin will be pulled low. When the fault condition is no longer present, the device will
enter the INITIALIZE state, but the nFLT pin will remain low until register 0 is read. When the register 0 is read, the nFLT pin
will go high until a new fault is detected.
Other Faults
When an open thermistor, thermal shut down, VIN under-voltage, or top off time-out are detected, charging will immediately
stop and the corresponding bit in register 0 will be set. The device will enter the INITIALIZE state until the fault is no longer
detected.
Specifications subject to change
WWW.TRIUNESYSTEMS.COM
-8-
Copyright © 2012, Triune Systems, LLC