EEV-FK0J471GP Datasheet, PDF (8/22 Pages) List of Unclassifed Manufacturers – Aluminum Electrolytic Capacitor

Electrolytic Capacitor Product Specification
V type FK series
CE-VFK-BE-33
6
No
Item
7 Robustness of
Termination
(Tensile)
Performance Characteristics
There is no damage or breakage after test.
Test
After fixing the capacitors, the terminals are
pulled in a vertical direction.
Load is gradually increased until it reached the
value specified below and held for 10 seconds.
Pull Strength
10N
Keep time
10±1sec.
8 Solderability
More than 95% of the terminal surface
shall be covered with new solder.
Exclude the cross-section of
cutting lead edge.
Solder Type : H60A,H60S,or H63A(JIS Z3282)
Solder Temperature : 235±5 ℃
Immersing Ｔime : 2±0.5 sec.
Immersing Depth : Dip the terminals for Approx.
0.5～1 mm thick
Flux : Approx 25% rosin(JIS K5902) in
Ethanol(JIS K8101)
9 Resistance to
Soldering heat
10 Solvent
Resistance of
the Marking
Leakage Current :
≦the value of item 6.1.
Capacitance Change :
Within ±10% of initial measured value.
Tangent of Loss Angle (tanδ) :
≦the value of item 6.3.
Appearance :
No significant change can be observed.
There shall be no damage end legibly
marked. Marking can be deciphered easily.
After reflow soldering (item 9 page 12)
The capacitor shall be left at room temperature
for before measurement.
Class of Reagent : Isopropyl Alcohol
Test Temperature : 20～25℃
Immersing time : 30±5 sec.
11 Damp Heat
(steady state)
Leakage Current :
≦the value of item 6.1.
Capacitance Change :
Within ±15% of initial measured value.
Tangent of Loss Angle (tanδ) :
≦120% the value of item 6.3.
Appearance :
No significant change can be observed.
Test Temperature : 40±2℃
Relative Humidity : 90～95%
Test Duration : 240±8 hours
After subjected to the test, the capacitors shall
be left for 2 hours at room temperature and
room humidity prior to the measurement.
Matsushita Electronic Components Co.,Ltd.　LCR Device Company
Capacitor Business Unit.