EEV-FK0J471GP Datasheet, PDF (7/22 Pages) List of Unclassifed Manufacturers – Aluminum Electrolytic Capacitor

Electrolytic Capacitor Product Specification
V type FK series
CE-VFK-BE-33
5
6．Performance Characteristics
No
Item
1 Leakage Current
2 Capacitance
Performance Characteristics
≦ I=0.01CV or 3μA whichever is the
greater.
　I:Leakage current C:Capacitance　
V:Rated voltage
Within the specified capacitance tolerance.
3 Tangent of Loss Less than tha table 1 value of page 9.
Angle
(tanδ)
4 Charact- Step 2 Impedance Ratio:
eristics at
Less than the table 2 value of page 9
High and
ratio against step 1.
Low Tem- Step 4 Leakage Current:
perature
≦800% of the value of item 6.1.
Capacitance Change:
Within ±25% of the value in step 1.
Tangent of Loss Angle (tanδ):
≦the value of item 6.3.
5 Surge
Leakage Current:
≦the value of item 6.1.
Capacitance Change:
Within ±15% of initial measured value.
Tangent of Loss Angle (tanδ):
≦the value of item 6.3.
Appearance:
No significant change can be observed.
6 Vibration
Capacitance :
During test, measured value shall be
stabilized.(Measured several times
within 30 min. before completion of
test)
Appearance :
No significant change can be observed.
Capacitance Change :
Within ±5% of initial measured value.
Test
Series Resistor : 1000±10Ω
Applied Voltage : Rated voltage
Measuring
: After 2 minutes
Measuring Frequency: 120Hz±20％
Measuring Circuit : Equivalent series circuit
Measuring Voltage : +1.5～2 V.DC
(≦0.5 V for A.C.)
Measuring Frequency: 120Hz±20％
Measuring Circuit : Equivalent series circuit
Measuring Voltage : +1.5～2 V.DC
(≦0.5 V for A.C.)
Step Test Temperature(℃)
Time
1
　20±2
―
2 -25±3,-40±3,-55±3 30 min.
3
　20±2
10～15 min.
4
105±2
30 min.
5
　20±2
10～15 min.
Impedance should be measured 120Hz±10％.
Test temperature : 15～35℃
Series Protective Resistance : R ^{100 r 50}
C
　 R: Protective resistance(kΩ)
C: Capacitance(μF)
Test voltage : Surge voltage item 3.5
Applied voltage : 1000 cycles of 30±5 sec
"ON"and 5 min 30 sec"OFF".
Frequency : 10～55 Hz　(1 minute per cycle.)
Total amplitudes : 1.5 mm
Direction and duration of vibration :
It is done in the X,Y,Z axis direction for 2
hours each, with a total of 6 hours.
Matsushita Electronic Components Co.,Ltd.　LCR Device Company
Capacitor Business Unit.