C8051F36X Datasheet, PDF (8/13 Pages) List of Unclassifed Manufacturers – C8051F36x DEVELOPMENT KIT

C8051F36x-DK
5.3. PORT I/O Connectors (J2 - J6)
In addition to all port I/O signals being routed to the 96-pin expansion connector, each of the five parallel ports of
the C8051F360 has its own 10-pin header connector. Each connector provides a pin for the corresponding port
pins 0–7, +3.3 VDC and digital ground. Table 3 defines the pins for the port connectors, where Pn represents P0
through P4. The same pin-out order is used for all of the port connectors.
Table 2. J12–J19 Port Connector Pin Descriptions
Pin #
1
2
3
4
5
6
7
8
9
10
Description
Pn.0
Pn.1
Pn.2
Pn.3
Pn.4
Pn.5
Pn.6
Pn.7 (not connected for J6)
+3 VD (+3.3 VDC)
GND (Ground)
5.4. Target Board DEBUG Interface (J9)
The DEBUG connector (J9) provides access to the DEBUG (C2) pins of the C8051F360. It is used to connect the
Serial Adapter or the USB Debug Adapter to the target board for in-circuit debugging and Flash programming.
Table 3 shows the DEBUG pin definitions.
Table 3. DEBUG Connector Pin Descriptions
Pin #
Description
1
+3 VD (+3.3 VDC)
2, 3, 9
GND (Ground)
4
C2D
5
/RST (Reset)
6
P4.6
7
C2CK
8
Not Connected
10 USB Power (from USB Debug Adapter)
8
Rev. 0.3