NUC442JI8AE Datasheet, PDF (77/228 Pages) –

ADC0_5
ACMP0_P1
SPI0_CLK
SD0_CDn
HS
120
PE.6
ADC0_6
ACMP0_P0
SPI0_MISO0
SD0_CMD
EBI_nWR
HS
121
PE.7
ADC0_7
ACMP0_N
SPI0_MOSI0
SD0_CLK
EBI_nRD
HS
122
AVSS
123
VREF
124
AVDD
125
PE.8
ADC1_0
ADC0_8
ACMP1_N
June 16, 2016
NUC442
A
MPF1
ADC0 analog input.
A
MPF2
Analog comparator0 positive input pin.
O
MPF3
SPI0 serial clock pin.
I
MPF4
SD mode #0 – card detect
Slew
This pad is embedded with “Slew Rate Control”
capability.
I/O
MFP0
General purpose digital I/O pin.
A
MPF1
ADC0 analog input.
A
MPF2
Analog comparator0 positive input pin.
I/O
MPF3
1st SPI0 MISO (Master In, Slave Out) pin.
I/O
MPF4
SD mode #0 – command/response
O
MPF7
EBI write enable output pin.
Slew
This pad is embedded with “Slew Rate Control”
capability.
I/O
MFP0
General purpose digital I/O pin.
A
MPF1
ADC0 analog input.
A
MPF2
Analog comparator0 negative input pin.
I/O
MPF3
1st SPI0 MOSI (Master Out, Slave In) pin.
O
MPF4
SD mode #0– clock.
O
MPF7
EBI read enable output pin.
Slew
This pad is embedded with “Slew Rate Control”
capability.
P
MFP0
Ground pin for digital circuit.
A
MFP0
Voltage reference input for ADC.
Note: This pin needs to be connected with
0.1uF/10uF capacitors.
P
MFP0
Power supply for internal analog circuit.
I/O
MFP0
General purpose digital I/O pin.
A
MPF1
ADC1 analog input.
A
MPF1
ADC0 analog input.
A
MPF2
Analog comparator1 negative input pin.
Page 77 of 228
Rev 1.09