KXCNL-1010 Datasheet, PDF (49/51 Pages) List of Unclassifed Manufacturers – Accelerometer Specifications

± 2g / 4g / 6g / 8g Tri-axis Digital
Accelerometer Specifications
PART NUMBER:
KXCNL-1010
Rev 3.0
State Program OP Codes
# Mnemonic Explanation
Notes
0h
NOP
No operation
1h
TI1
Timer 1 valid
Execution moved to next or
resetconditions in state
Data samples are not evaluated
2h
TI2
Timer 2 valid
Data samples are not evaluated
3h
TI3
Timer 3 valid
Data samples are not evaluated
4h
TI4
Timer 4 valid
Data samples are not evaluated
5h
GNTH1
Any/triggered axis greater than threshold 1
First axis triggers
6h
GNTH2
Any/triggered axis greater than threshold 2
First axis triggers
7h
LNTH1
Any/triggered axis less than or equal to threshold 1
First axis triggers
8h
LNTH2
Any/triggered axis less than or equal to threshold 2
First axis triggers
9h
GTTH1
Any/triggered axis greater than threshold 1
First axis triggers
Ah
LLTH2
All axis less than or equal to threshold 2
First masked axis triggers
Bh
GRTH1
Any/triggered axis greater than to reversed threshold 1 First axis triggers
Ch
LRTH1
Any/triggered axis less than or equal to reversed
threshold 1
First axis triggers
Dh
GRTH2
Any/triggered axis greater than to reversed threshold 2 First axis triggers
Eh
LRTH2
Any/triggered axis less than or equal to reversed
threshold 2
Fh
NZERO
Any axis zero crossed
First axis triggers
Uses previous data samples sign
First axis triggers
Table 1. Conditions
#
Mnemonic Explanation
00h
STOP
Stop execution, and resets reset-point to
start
11h
CONT
Continues execution from reset-point
Jump address for two Next conditions
22h
JMP
- 1^st parameter is conditions
- 2^nd parameter are addresses for valid
conditions
33h
SRP
Set reset-point to next address / state
44h
CRP
Clear reset-point to start position (to 1^st
address)
Set parameter in register memory
55h
SETP
-1^st is address of parameter
- 2^nd parameter is new parameter set to
address
66h
SETS1
Set new setting to Settings 1 register
- 1^st is new settings byte
77h
STHR1
Set new value to /THRS1_y register
- 1^st is new settings byte
88h
OUTC
Set outputs to output registers
Run Scope
Immediately
Immediately
Notes
Output also if enabled
Output also if enabled
Immediately for command Special (command and
& Sample for conditions conditions)
Immediately
Immediately
Immediately
Immediately
Immediately
Immediately output
Address parameter is direct
absolute pointer to register
memory
36 Thornwood Dr. – Ithaca, NY 14850
tel: [phone] – fax:[phone]
www.kionix.com - [e-mail]
© 2013 Kionix – All Rights Reserved
1.0
Page 49 of 51