|
M058SFAN Datasheet, PDF (47/72 Pages) List of Unclassifed Manufacturers – 32-bit Microcontroller | |||
|
◁ |
NuMicroï¤ M058S Series Datasheet
6.10 UART Interface Controller (UART)
6.10.1 Overview
The NuMicroTM M058S provides two channels of Universal Asynchronous Receiver/Transmitters
(UART). UART Controller performs Normal Speed UART, and support flow control function. The
UART Controller performs a serial-to-parallel conversion on data received from the peripheral,
and a parallel-to-serial conversion on data transmitted from the CPU. The UART controller also
supports IrDA SIR Function, LIN master/slave function and RS-485 function mode. Each UART
Controller channel supports seven types of interrupts.
6.10.2 Features
ï¬ Full duplex, asynchronous communications
ï¬ Separate receive / transmit 16/16 bytes entry FIFO for data payloads
ï¬ Supports hardware auto flow control/flow control function (CTS, RTS) and programmable
RTS flow control trigger level
ï¬ Programmable receiver buffer trigger level
ï¬ Supports programmable baud-rate generator for each channel individually
ï¬ Supports CTS wake up function
ï¬ Supports 8 bit receiver buffer time out detection function
ï¬ Programmable transmitting data delay time between the last stop and the next start bit by
setting UA_TOR [DLY] register
ï¬ Supports break error, frame error, parity error and receive / transmit buffer overflow detect
function
ï¬ Fully programmable serial-interface characteristics
ï® Programmable number of data bit, 5, 6, 7, 8 bit character
ï® Programmable parity bit, even, odd, no parity or stick parity bit generation and
detection
ï® Programmable stop bit, 1, 1.5, or 2 stop bit generation
ï¬ Supports IrDA SIR function mode
ï® Supports for 3/16 bit duration for normal mode
ï¬ Supports LIN function mode
ï® Supports LIN master/slave mode
ï® Supports programmable break generation function for transmitter
ï® Supports break detect function for receiver
ï¬ Supports RS-485 function mode.
ï® Supports RS-485 9bit mode
ï® Supports hardware or software enable to program RTS pin to control RS-485
transmission direction directly
Nov. 27, 2014
Page 47 of 72
Rev.1.03
|
▷ |