CME6005 Datasheet, PDF (4/16 Pages) List of Unclassifed Manufacturers – Single and dual band receiver IC

Preliminary Data Sheet CME6005 C-MAX
VCC, GND
V_CC and GND are the supply voltage inputs. The positive supplies have to be connected externally, and also
the ground pins.
To power down the circuitry it is recommended to use the PON input and not to switch the power supply.
Switching the power supply results in a long power up waiting time.
PON
If PON is connected to GND, the receiver will be activated. The setup time is typically 0.5 sec after applying
GND to this pin. If PON is connected to VCC, the receiver will switch to Power Down mode.
TCO, TCON
The serial signal of the time-code transmitter can be directly decoded by a micro controller. Details about the
time-code format of several transmitters are described separately. If TCO is connected, TCON must be open
or counterwise.
SPEC No.
CME6005
Revision
A.7
State
07.12.04
C-MAX printed
07.12.2004
Version
English
Page
4 of 16