RFD21733 Datasheet, PDF (30/76 Pages) List of Unclassifed Manufacturers – Compliance Approved 2.4 GHz RF Transceiver Modules with Built-In RFDP8 Application Protocol

© Copyright, RF Digital
7/10/2011 1:40 AM
Patents Pending
RoHS CE • ESTI
RFD21733 • FCC • IC
RFD21743 • FCC
Approved & Certified
13715 Alton Pkwy • Irvine • CA • 92618
Tel: [phone] • www.RFdigital.com
Fast Answers: [e-mail]
RFDP8
RF Module
RFD21733
RFD21735
RFD21737
RFD21738
RFD21739
RFDP8
RFDANT
RFD21742
RFD21743
RFD21772
RFD21773
KEYFOBs
Table for Eval Boards ONLY - RFD21737, RFD21738, RFD21739, RFD21772, RFD21773.
EVAL Pin Label
Direction
Pull Up or Pull Down
BOARD
1 GND
Input
Ground
2 +V
Input
+V Power
3 ON
Input
On input to on-board regulator. Tie to +V for board to run.
4 FACTORY
Input
3.3k pull down. (Inside of Modules and RFDANTs)
5 RESET
Input
3.3k pull up. (Inside of Modules and RFDANTs)
6 Mode Select 0
Input
13k ohm pull down for about 1mS after reset or after power
up. (Inside of Modules and RFDANTs)
7 Mode Select 1
Input
47k pull down mounted on Eval Board.
8 Mode Select 2
Input
47k pull down mounted on Eval Board.
9 TX LED / Status / Learn Input / Output 47k pull down mounted on Eval Board.
10 IN1 / OUT1 / LOGIC IO Input / Output 47k pull down mounted on Eval Board.
11 IN2 / OUT2 / RXD
Input / Output 47k pull down mounted on Eval Board.
12 IN3 / OUT3 / TXD
Input / Output 47k pull down mounted on Eval Board.
Free Schematic, Layout and Application Design Reviews
For free Application, Schematic and Layout design reviews, send color screen captures or PDFs of your
schematic and layout to [e-mail]. RF Digital’s Support and Application Engineers are ready to get
your wireless application running today. Why spend lots of time reading volumes of data? Instead, simply send
your application questions to [e-mail] and receive direct, fast and personal answers focused on
your specific project and needs. We look forward to hearing from you!!!
MODES
Mode 0 – Active RFID Transmitter
RFDANT Module Pin Label
Pin # Pin #
2
13 +V
1
10 GND
5
16 Mode Select 0
6
17 Mode Select 1
7
3 Mode Select 2
8
4 TX LED
9
5 IN1
10
6 IN2
11
7 IN3
Direction Function
Input
Input
Input
Input
Input
Output
Input
Input
Input
+V Power
Ground
Tie to GND
Tie to GND
Tie to GND
Toggles high during transmission (1 blink every 2 seconds)
Active high switch input #1 (optional) if not used, pull to
GND.
Active high switch input #2 (optional) if not used, pull to
GND.
Active high switch input #3 (optional) if not used, pull to
GND.
Free Applications Support • Email your application questions to [e-mail]
30