UG-2828GDEDF02 Datasheet, PDF (27/29 Pages) List of Unclassifed Manufacturers – OEL Display Module

Univision Technology Inc. Doc. No: SAS1-XXXX-A
8. Precautions When Using These OEL Display Modules
8.1 Handling Precautions
1) Since the display panel is being made of glass, do not apply mechanical impacts
such us dropping from a high position.
2) If the display panel is broken by some accident and the internal organic
substance leaks out, be careful not to inhale nor lick the organic substance.
3) If pressure is applied to the display area, both of top and back sides, or its
neighborhood of the OEL display module, the cell structure may be damaged
and be careful not to touch these sections on carrying and assembly.
4) The polarizer covering the surface of the OEL display module is soft and easily
scratched. Please be careful when handling the OEL display module.
5) When the surface of the polarizer of the OEL display module has soil, clean the
surface. It takes advantage of by using following adhesion tape.
* Scotch Mending Tape No. 810 or an equivalent
Never try to breathe upon the soiled surface nor wipe the surface using cloth
containing solvent such as ethyl alcohol, since the surface of the polarizer will
become cloudy.
Also, pay attention that the following liquid and solvent may spoil the polarizer:
* Water
* Ketone
* Aromatic Solvents
6) When installing the OEL display module, be careful not to apply twisting stress
or deflection stress to the OEL display module. And, do not over bend the
film with electrode pattern layouts. These stresses will influence the display
performance. Also, secure sufficient rigidity for the outer cases.
7) Do not apply stress to the LSI chips and the surrounding molded sections.
8) Do not disassemble nor modify the OEL display module.
9) Do not apply input signals while the logic power is off.
10) Pay sufficient attention to the working environments when handing OEL
display modules to prevent occurrence of element breakage accidents by static
electricity.
* Be sure to make human body grounding when handling OEL display
modules.
* Be sure to ground tools to use or assembly such as soldering irons.
* To suppress generation of static electricity, avoid carrying out assembly work
under dry environments.
* Protective film is being applied to the surface of the display panel of the OEL
display module. Be careful since static electricity may be generated when
exfoliating the protective film.
11) Protection film is being applied to the surface of the display panel and removes
the protection film before assembling it. At this time, if the OEL display
module has been stored for a long period of time, residue adhesive material of
the protection film may remain on the surface of the display panel after
removed of the film. In such case, remove the residue material by the method
introduced in the above Section 5).
12) If electric current is applied when the OEL display module is being dewed or
when it is placed under high humidity environments, the electrodes may be
corroded and be careful to avoid the above.
22