ZADCS1082_11 Datasheet, PDF (23/27 Pages) List of Unclassifed Manufacturers – 10-Bit, 250ksps, ADC Family

ZADCS1082/1042/1022
10-Bit, 250ksps, ADC Family
Hardware Power Down
The third power down mode is called Hardware Power-Down. It is initiated by pulling the nSHDN pin LOW. If
this condition is true, the device will immediately shut down all circuitry just as in Full Power Down-Mode.
The IC wakes up if nSHDN is tied HIGH. There is no internal pull-up that would allow nSHDN to float during
normal operation. This ensures the lowest possible power consumption in power down mode.
General Power Considerations
Even without activating any power down mode, the devices out of the ZADCS10x2 family reduce their power
consumption between conversions automatically. The comparator, which contributes a considerable amount
to the overall current consumption of the device, is shut off as soon as a conversion is ended. It gets turned on
at the start of the next acquisition period. This explains the difference between the IDDstatic and IDDactive
measurements shown in chapter 1.6 Typical Operating Characteristics.
The average current consumption of the device depends very much on the sampling frequency and the type
of protocol used to communicate with the device.
In order to achieve the lowest power consumption at low sampling frequencies, it is suggested to keep the
conversion clock frequency at the maximum level of 3.3MHz and to power down the device between
consecutive conversions. Figure 18 shows the characteristic current consumption of the ZADCS10x2 family
with external reference supply versus Sampling Rate
Data Sheet
October 12, 2011
© 2011 Zentrum Mikroelektronik Dresden AG — Rev. 2.0
All rights reserved. The material contained herein may not be reproduced, adapted, merged, translated, stored, or used without
the prior written consent of the copyright owner. The information furnished in this publication is PRELIMINARY and subject to
changes without notice.
23 of 26