SGN01G64A2BG1MT-BBRT Datasheet, PDF (2/15 Pages) List of Unclassifed Manufacturers – 1024MB DDR3 – SDRAM SO-DIMM

Data Sheet
Rev.1.0 08.11.2010
This Swissbit module is an industry standard 204-pin 8-byte DDR3 SDRAM Small Outline Dual-In-line Memory
Module (SO-DIMM) which is organized as x64 high speed CMOS memory arrays. The module uses internally
configured octal-bank DDR3 SDRAM devices. The module uses double data rate architecture to achieve high-
speed operation. DDR3 SDRAM modules operate from a differential clock (CK and CK#). READ and WRITE
accesses to a DDR3 SDRAM module is burst-oriented; accesses start at a selected location and continue for a
programmed number of locations in a programmed sequence. The burst length is either four or eight locations. An
auto precharge function can be enabled to provide a self-timed row precharge that is initiated at the end of a burst
access. The DDR3 SDRAM devices have a multibank architecture which allows a concurrent operation that is
providing a high effective bandwidth. A self refresh mode is provided and a power-saving “power-down” mode. All
inputs and all full drive-strength outputs are SSTL_15 compatible.
The DDR3 SDRAM module uses the serial presence detect (SPD) function implemented via serial EEPROM
using the standard I²C protocol. This nonvolatile storage device contains 256 bytes. The first 128 bytes are
utilized by the SO-DIMM manufacturer (Swissbit) to identify the module type, the module’s organization and
several timing parameters. The second 128 bytes are available to the end user.
Module Configuration
Organization DDR3 SDRAMs used
128M x 64bit 8 x 128M x 8bit (1024Mbit)
Row
Addr.
14
Device Bank
Addr.
BA0, BA1, BA2
Column
Addr.
10
Refresh
Module
Bank Select
8k
S0#
Module Dimensions
in mm
67.60 (long) x 30(high) x 3.80 [max] (thickness)
Timing Parameters
Part Number
SGN01G64A2BG1MT-BBRT
SGN01G64A2BG1MT-CCRT
Module Density
1024 MB
1024 MB
Transfer Rate
8.5 GB/s
10.6 GB/s
Clock Cycle/Data bit rate
1.87ns/1066MT/s
1.5ns/1333MT/s
Latency
7-7-7
9-9-9
Pin Name
A0-9, A11 – A13
A10/AP
BA0 – BA2
DQ0 – DQ63
DM0-DM7
DQS0 - DQS7
DQS0# - DQS7#
S0#
RAS#
CAS#
WE#
CKE
ODT0
Swissbit AG
Industriestrasse 4
CH – 9552 Bronschhofen
Address Inputs
Address Input / Autoprecharge Bit
Bank Address Inputs
Data Input / Output
Input Data Mask
Data Strobe, positive line
Data Strobe, negative line (only used when differential data strobe mode is enabled)
Chip Select
Row Address Strobe
Column Address Strobe
Write Enable
Clock Enable
On-Die Termination
Fon: [phone]
Fax: [phone]
www.swissbit.com
eMail: [e-mail]
Page 2
of 15