SGN01G64A2BG1MT-BBRT Datasheet, PDF (1/15 Pages) List of Unclassifed Manufacturers – 1024MB DDR3 – SDRAM SO-DIMM

Data Sheet
Rev.1.0 08.11.2010
1024MB DDR3 – SDRAM SO-DIMM
204 Pin SO-DIMM
SGN01G64A2BG1MT-xxRT
1GByte in FBGA Technology
RoHS compliant
Options:
 Data Rate / Latency
DDR3 1066 MT/s CL7
DDR3 1333 MT/s CL9
 Module density
1024MB with 8 dies and 1 rank
Marking
-BB
-CC
Features:
 204-pin 64-bit DDR3 Small Outline Dual-In-Line Double
Data Rate Synchronous DRAM module
 Module organization: single rank 128M x 64
 VDD = 1.5V ±0.075V, VDDQ 1.5V ±0.075V
 1.5V I/O ( SSTL_15 compatible)
 On-board I2C temperature sensor with integrated serial
presence-detect (SPD) EEPROM
 Gold-contact pads
 This module is fully pin and functional compatible to the
JEDEC PC3-10600 spec. and JEDEC- Standard MO-268.
(see www.jedec.org)
 The pcb and all components are manufactured according
to the RoHS compliance specification [EU Directive
2002/95/EC Restriction of Hazardous Substances (RoHS)]
 Standard Grade
Grade E
Grade W
(T_A) 0°C to 70°C

(T_C) 0°C to 85°C
(T_A) 0°C to 85°C
(Tc) 0°C to 95°C *)

(T_A)
(Tc)
-40°C to 85°C ^
-40°C to 95°C *) ^
*) The refresh rate has to be doubled when 85°C<TC<95°C 
Environmental Requirements:

 Operating temperature (ambient)

Standard Grade
0°C to 70°C

Grade E
0°C to 85°C
Grade W
-40°C to 85°C
DDR3 - SDRAM component Micron
MT41J128M8JP-15E DIE-Rev.G
128Mx8 DDR3 SDRAM in PG-TFBGA-78 package
8-bit pre-fetch architecture
Programmable CAS Latency, CAS Write Latency, Additive
Latency, Burst Length and Burst Type.
On-Die-Termination (ODT) and Dynamic ODT for improved
signal integrity.
Refresh. Self Refresh and Power Down Modes.
ZQ Calibration for output driver and ODT.
System Level Timing Calibration Support via Write Leveling
and Multi Purpose Register (MPR) Read Pattern.
 Operating Humidity
10% to 90% relative humidity, noncondensing
 Operating Pressure
105 to 69 kPa (up to 10000 ft.)
 Storage Temperature
-55°C to 100°C
 Storage Humidity
5% to 95% relative humidity, noncondensing
 Storage Pressure
1682 PSI (up to 5000 ft.) at 50°C
Figure: mechanical dimensions¹
Swissbit AG
Industriestrasse 4
CH – 9552 Bronschhofen
Fon: [phone]
Fax: [phone]
1_{if no tolerances specified ± 0.15mm}
www.swissbit.com
eMail: [e-mail]
Page 1
of 15