BXRA-56C0700 Datasheet, PDF (18/24 Pages) List of Unclassifed Manufacturers – Bridgelux ES Star Array Series

Mechanical Dimensions
Figure 12: Drawing for ES Star Arrays
Notes for Figure 12:
1. Mounting holes are for M2.5 or #4 screws.
2. Solder pads are labeled “+” and “-“ to denote positive and negative, respectively.
3. It is not necessary to provide electrical connections to both sets of solder pads. Either set may be
used depending on application specific design requirements.
4. Drawings are not to scale.
5. Drawing dimensions are in millimeters.
6. Unless otherwise specified, tolerances are ± 0.10mm.
7. The optical center of the LED Array is nominally defined by the mechanical center of the array.
The light emitting surface (LES) is centered on the mechanical center of the array to a tolerance
of ± 0.45 mm
8. Bridgelux maintains a flatness of 0.1 mm across the mounting surface of the array. Refer to
Application Notes AN10 and AN11 for product handling, mounting and heat sink
recommendations.
Bridgelux ES Star Array Series Product Data Sheet DS23 (8/30/2013 rev2)
Page 18 of 24