YS05S16-0G Datasheet, PDF (14/23 Pages) List of Unclassifed Manufacturers – GPS Module TC6000GN-P1

GPS Module TC6000GN-P1
Datasheet V022
confidential information preliminary specification
11 HARDWARE HOST INTERFACE
TC6000GN-P1 is connected to host system by a UART Interface.
Since TC6000GN-P1 is used only to deliver NMEA to the host only a single data line from the
module to the host is necessary.
The interface is requires 1.8V I/O.
The idle state of the lines is positive voltage. To interface a standard RS232 UART (e.g. a PC serial
interface), please add an inverting level shifter. To interface processors that have a different
interfacing voltage level, level shifters are required.
11.1 GPS UART Interface details
The UART interface is used to send NMEA messages and control data.
The default baud rate is 9600, other baud rates can be selected by ordering option.
The maximum baud rate deviation supported is ±2%.
Parameter
Baud rate
Data length
Stop bit
Parity
GPS UART Default Settings
Value
9600
8 bits
1
None
12 NMEA DATA
The TC6000GN-P1 provides NMEA (National Marine Electronics Association) 0183 compatible data.
The following table shows the available NMEA sentences
All active NMEA sentences are sent at the selected rate
Type
$GPRMC
$GPGGA
$GPGSV
$GPGLL
$GPGSA
$GPVTG
NMEA available sentences
content
Recommended Minimum Navigation Information
Global Positioning System Fix Data, Time, Position and fix
related data for a GPS receiver
Satellites in view
Geographic Position - Latitude/Longitude
GPS DOP and active satellites
Track made good and Ground speed
14
© GNS-GmbH 2011
V 0.22, Sep5^th 2012