MK02FN128VLH10 Datasheet, PDF (1/56 Pages) List of Unclassifed Manufacturers – 100 MHz Cortex-M4 Based Microcontroller with FPU

Freescale Semiconductor, Inc.
Data Sheet: Technical Data
K02P64M100SFA
Rev. 3, 4/2015
Kinetis K02 64 KB/128 KB Flash
100 MHz Cortex-M4 Based Microcontroller with FPU
MK02FN128Vxx10
MK02FN64Vxx10
Ideal for low-power applications that require processing
efficiency. These devices share the comprehensive enablement
and scalability of the Kinetis family.
This product offers:
• Run power consumption down to 117.5 µA/MHz and static
power consumption down to 2.8 µA with full state retention
and 5.7 µs wakeup. Lowest static mode down to 70 nA.
• Excellent processing efficiency, 100 MHz ARM^® Cortex^®-
M4-based device with floating-point unit in a tiny form factor
64 LQFP (LH)
10 x 10 x 1.4 Pitch 0.5
mm
48 LQFP (LF)
7 x 7 x 1.4 Pitch 0.5
mm
32 QFN (FM)
5 x 5 x 1 Pitch 0.5 mm
Performance
• 100 MHz ARM Cortex-M4 core with DSP instructions
delivering 1.25 Dhrystone MIPS per MHz
Memories and memory interfaces
• Up to 128 KB of embedded flash and 16 KB of RAM
• Preprogrammed Kinetis flashloader for one-time, in-
system factory programming
System peripherals
• Flexible low-power modes, multiple wake up sources
• 4-channel DMA controller
• Independent External and Software Watchdog monitor
Clocks
• Crystal oscillator: 32-40 kHz or 3-32 MHz
• Three internal oscillators: 32 kHz, 4 MHz, and 48 MHz
• Multi-purpose clock generator with FLL
Security and integrity modules
• Hardware CRC module
• 128-bit unique identification (ID) number per chip
• Flash access control to protect proprietary software
Human-machine interface
• Up to 46 general-purpose I/O (GPIO)
Analog modules
• One 16-bit SAR ADC (1.2 MS/s in 12bit mode)
• One 12-bit DAC
• Two analog comparators (CMP) with 6- bit DAC
• Accurate internal voltage reference (not available in
32-pin QFN package)
Communication interfaces
• One SPI module
• Two UART modules
• One I2C: Support for up to 1 Mbps operation
Timers
• One 6-channel general-purpose/PWM timer
• Two 2-channel general-purpose timers with
quadrature decoder functionality (FTM2 does not
have external pins on the 32-pin QFN or the 48-pin
LQFP package)
• Periodic interrupt timers
• 16-bit low-power timer
• Programmable delay block
Operating Characteristics
• Voltage range (including flash writes): 1.71 to 3.6 V
• Temperature range (ambient): -40 to 105°C
© 2014–2015 Freescale Semiconductor, Inc. All rights reserved.