LP150X1 Datasheet, PDF (7/20 Pages) List of Unclassifed Manufacturers – DATA DISPLAY AG LP150X1 15.0 XGA TFT LCD PRELIMINARY SPECIFICATION

SPECIFICATIONS
TITLE: LP150X1 LIQUID CRYSTAL DISPLAY
LP150X1 REV. 1.0 PAGE 7 OF 20
5. INTERFACE CONNECTIONS
This LCD employs two interface connectors, a 20-pin connector is used for the
module electronics and a two-pin connector is used for the integral backlight system.
The electronics interface connector is FI-SEB20P-HF13, manufactured by JAE, or
equivalent. Mating connector is FI-SEB20S made by JAE, or equivalent. The pin
configuration for the connector is shown in the table below.
Table 4: Pin Configuration Of Module Connector
Pin Symbol Description
Remark
1
VDD Power supply, 3.3V
2
VDD Power supply, 3.3V
3
GND Ground
4
GND Ground
5
A1M Receiver signal ( -) Red data R0 ~ R5, G0
6
A1P Receiver signal (+) Red data R0 ~ R5, G0
7
GND Ground
8
A2M Receiver signal ( -) Green data G1 ~ G5, B0 ~ B1
9
A2P Receiver signal (+) Green data G1 ~ G5, B0 ~ B1
10 GND Ground
11
A3M
Receiver signal ( -)
Blue data B2 ~ B5, Hsync,
Vsync, DTMG
12
A3P
Receiver signal (+)
Blue data B2 ~ B5, Hsync,
Vsync, DTMG
13 GND Ground
14 CLKM Clock signal ( -)
Main clock
15 CLKP Clock signal (+)
Main clock
16 GND Ground
17 NC Reserved
18 NC Reserved
19 GND Ground
20 GND Ground
Connector placement
1
20
Front View
Connecting direction
Note 1: All GND(ground) pins should be connected.
Note 2: All V_DD(input power) pins should be connected together.
The backlight interface connector is a model BHSR-02VS-1, manufactured by JST.
The mating connector part number is SM02B-BHSS-1 or equivalent. The pin
configuration for the connector is shown in the table below.
Table 5 Pin Configuration Of Backlight Connector
Pin
Symbol
Description
Remark
1
HV
Lamp power input
Note 1
2
LV
Ground
Note 1: The input power terminal is colored pink.
DATA DISPLAY AG
Industriestrasse 1
D-82110 Germering
APRIL 2001
http://www.datadisplay.de
Tel.: [phone]
Fax: [phone]