LP150X1 Datasheet, PDF (18/20 Pages) List of Unclassifed Manufacturers – DATA DISPLAY AG LP150X1 15.0 XGA TFT LCD PRELIMINARY SPECIFICATION

SPECIFICATIONS
TITLE: LP150X1 LIQUID CRYSTAL DISPLAY
LP150X1 REV. 1.0 PAGE 18 OF 20
15.4 Precaution For Strong Light Exposure
Strong light exposure causes degradation of polarizer and color filter.
15.5 Storage
When storing module as spares for long time, the following precautions are
necessary.
• Store them in a dark place; do not expose then to sunlight or fluorescent light.
Keep the temperature between 5 and 35 at normal humidity.
• The polarizer surface should not come in contact with any other object. It is
recommended that they be stored in the container in which they were shipped.
15.6 Handling Precautions For Protection Film
• When the protection film is pealed off, static electricity is generated between the
film and the polarizer. This film should be pealed off slowly and carefully by
people who are electrically grounded and with well ion-blown equipment or in
such a condition.
• The protection film is attached the polarizer with a small amount of glue. If
some stress is applied to rub the protection film against the polarizer during the
time you peal off the film, the glue is apt to remain more on the polarizer. So
please carefully peal off the protection film without rubbing it against the
polarizer.
• When the module with protection film attached is stored for long time,
sometimes there remains a very small amount of glue still on the polarizer after
the protection film is pealed off. Please refrain from storing the module at the
high temperature and high humidity for glue is apt to remain in this condition.
• The glue may be taken for the module failure, but you can remove the glue
easily. When the glue remains on the polarizer surface or its vestige is
recognized, please wipe them off with absorbent cotton waste or other soft
material like chamois soaked with Normal-hexane.
15.7 Safety
• If module is broken, be careful to handle not to injure. (TFT-LCD and lamp are
made of glass) Please wash hands sufficiently when you touch the liquid crystal
coming out from broken LCDs.
• As it is possible for PCB or other electronic parts of module to small to smoke
and to take fire because of the short circuit. Please design the circuit of your
instrument not to flow the electric current to TFT-LCD module more than
500mA.
• As backlight unit has an internal high voltage circuit, do not open the case and
do not insert foreign materials in the case.
DATA DISPLAY AG
Industriestrasse 1
D-82110 Germering
APRIL 2001
http://www.datadisplay.de
Tel.: [phone]
Fax: [phone]