|
HD49801FB Datasheet, PDF (22/43 Pages) List of Unclassifed Manufacturers – Digital Signal Processing IC for CCD Cameras | |||
|
◁ |
HD49801FB
HD49801FB
State Data A12 (1 to 5): White balance detection
This data determines the white balance detection region, sets the dead band, and determines the control
range.
Address H
Address
Data
D1 D2 D3 D4 D5 D6 D7 D8 D9 D10 D11 D12 D13 D14 D15 D16 D17 D18 D19 D20 D21
R-Y gain
B-Y gain
1 1 1 0 1 0 0 0 D1 D2 D3 D4 D1 D2 D3 D4
Y level 1
Y level 2
2 1 1 0 1 1 0 0 D1 D2 D3 D4 D1 D2 D3 D4
Offset +
Offset â
3 1 1 0 1 0 1 0 D1 D2 D3 D4 D5 D6 D1 D2 D3 D4 D5 D6
C level 1 +
C level 1 â
4 1 1 0 1 1 1 0 D1 D2 D3 D4 D5 D6 D7 D1 D2 D3 D4 D5 D6 D7
C level 2 +
C level 2 â
5 1 1 0 1 0 0 1 D1 D2 D3 D4 D5 D6 D7 D1 D2 D3 D4 D5 D6 D7
1: R-Y gain, B-Y gain
These adjust the R-B/Mg-g detection axis.
Gain = D4 Ã 2â1 + D3 Ã 2â2 + D2 Ã 2â3 + D1 Ã 2â4
2: Y level 1, Y level 2
When the Y signal is used as the white detection area data, the Y signal detection range is set by Y
level 1 (lower bits) and Y level 2 (upper bits).
The data consists of 8 bits, and the upper 4 bits (D1 to D4) can be changed.
3: Offset
The control center can be shifted by setting the offset.
Of the 8 bits of this data, the data that can be changed consists of 6 bits (64/256 = 1/4), and the offset
level can be changed over up to 1/4 of the full data range.
22
|
▷ |