HAL571 Datasheet, PDF (7/20 Pages) List of Unclassifed Manufacturers – Two-Wire Hall Effect Sensor Family

ADVANCE INFORMATION
HAL57x, HAL58x
3.4. Absolute Maximum Ratings
Symbol
V_DD
I_DDZ
Parameter
Supply Voltage
Supply Current through
Protection Device
Pin No.
1
1
Min.
–15^{1) 2)}
–50²⁾
–200³⁾
Max.
28²⁾
50²⁾
200³⁾
T_S
Storage Temperature Range
–65
150
T_J
Junction Temperature Range
–40
150
1) _{–18 V with a 100 Ω series resistor at pin 1 (–16 V with a 30 Ω series resistor)}
2) _{as long as TJmax is not exceeded}
2) _{with a 220 Ω series resistance at pin 1 corresponding to test circuit 1 (see Fig. 5–3)}
3) _{t < 2 ms}
Unit
V
mA
mA
°C
°C
Stresses beyond those listed in the “Absolute Maximum Ratings” may cause permanent damage to the device. This
is a stress rating only. Functional operation of the device at these or any other conditions beyond those indicated in the
“Recommended Operating Conditions/Characteristics” of this specification is not implied. Exposure to absolute maxi-
mum ratings conditions for extended periods may affect device reliability.
3.5. Recommended Operating Conditions
Symbol
Parameter
V_DD
Supply Voltage
T_A
Ambient Temperature for Continuous
Operation
t_on
Supply Time for Pulsed Mode
1) _{when using the the “K” type and VDD ≤ 16 V}
Pin No.
1
Min.
3.75
–40
30
Max.
24
85¹⁾
–
Unit
V
°C
µs
Note: Due to the high power dissipation at high current consumption, there is a difference between the ambient temper-
ature (T_A) and junction temperature. The power dissipation can be reduced by repeatedly switching the supply voltage
on and off (pulse mode). Please refer to section 5.4. on page 19 for details.
Micronas
7