GO7007 Datasheet, PDF (7/10 Pages) List of Unclassifed Manufacturers – WIS GO7007 Single-Chip Streaming Media Encoder

SCAN_EN
11
BIST_FAIL
205
BIST_DONE
206
BIST_RESET
207
BIST_RUN
208
Debug Pins
XP_INT0/ TDI
15
CBUS_IORDY/ TCK
16
CBUS_WE/ TMS
21
CBUS_ALE/ TRST
22
CBUS_AD15-
CBUS_AD0
23-27,
30-31,
165-173
DEBUG_MODE
204
DBG_INT
198
SYNC_HPI
197
RET_INT/TDO
18
INT_ACK/ MON_EN
17
BOOT_SEL
12
Input
Output
Output
Input
Input
Output/
Input
Output/
Input
Output/
Input
Output/
Input
Output
Input
Input
Input
Output
Input
Input
Scan Enable. Reserved for manufacturers’
use. Connect pin to ground under normal
operation.
Built-In Self Test Fail indicator
Built-In Self Test Done indicator
Built-In Self Test Reset. Reserved for
manufacturers’ use. Connect pin to logic 1
under normal operation.
Built-In Self Test start. Reserved for
manufacturers’ use. Connect pin to
ground under normal operation.
Reserved for manufacturers’ use
When Control Bus monitor is enabled, this
pin monitors Internal XRISC Interrupt #0.
Otherwise, it is used as Test Data Input
for the JTAG interface. If JTAG is not
used, a 10kΏ pull-up is required.
When Control Bus monitor is enabled, this
pin monitors the internal Control Bus
IO_Ready. Otherwise, it is used as a Test
Clock for the JTAG interface. If JTAG is
not used, a 10kΏ pull-up is required.
When Control Bus monitor is enabled, this
pin monitors internal Control Bus Write
Enable. Otherwise, it is used as a Test
Mode Select for the JTAG interface; a
10kΏ pull-up is required.
When Control Bus monitor is enabled, this
pin monitors internal Control Bus Address
Latch Enable. Otherwise, it is used as a
Test Reset for the JTAG interface; a 10kΏ
pull-up is required.
When Control Bus monitor is enabled,
these pins are connected to the internal
Control Bus Address and Data. When
CBUS_ALE is 1, the Address on the
Control Bus is output. Otherwise, Data on
Control Bus is output.
10kΏ pull-down is required.
Reserved; 10kΏ pull-down is required.
Reserved; 10kΏ pull-down is required.
Reserved in functional mode. In JTAG
mode, this pin is the Test Data Output for
the JTAG interface.
Reserved; 10kΏ pull-down is required.
Reserved; 10kΏ pull-down is required.
PAGE 7