S93662 Datasheet, PDF (4/14 Pages) List of Unclassifed Manufacturers – Voltage Monitor and Reset Controller

S93662/S93663
writing or clearing of the device. Data can be read
normally from the device regardless of the write enable/
disable status.
Erase All
Upon receiving an ERAL command, the CS (Chip
Select) pin must be deselected for a minimum of 250ns
(tCSMIN). The falling edge of CS will start the self clocking
clear cycle of all memory locations in the device. The
clocking of the SK pin is not necessary after the device
has entered the self clocking mode. The ready/busy
status of the S93662/663 can be determined by select-
ing the device and polling the DO pin. Once cleared, the
contents of all memory bits return to a logical “1” state.
Write All
Upon receiving a WRAL command and data, the CS
(Chip Select) pin must be deselected for a minimum of
250ns (tCSMIN). The falling edge of CS will start the self
clocking data write to all memory locations in the device.
The clocking of the SK pin is not necessary after the
device has entered the self clocking mode. The ready/
busy status of the S93662/663 can be determined by
selecting the device and polling the DO pin. It is not
necessary for all memory locations to be cleared before
the WRAL command is executed.
Page Write
93662 - Assume WEN has been issued. The host will
then take CS high, and begin clocking in the start bit,
write command and 9-bit byte address immediately
followed by the first byte of data to be written. The host
can then continue clocking in 8-bit bytes of data with
each byte to be written to the next higher address.
Internally the address pointer is incremented after
receiving each group of eight clocks; however, once
the address counter reaches x xxxx 1111 it will roll over
to x xxxx 0000 with the next clock. After the last bit is
clocked in no internal write operation will occur until CS
is brought low.
93663 - Assume WEN has been issued. The host will
then take CS high, and begin clocking in the start bit,
write command and 8-bit byte address immediately
followed by the first 16-bit word of data to be written.
The host can then continue clocking in 16-bit words of
data with each word to be written to the next higher
address. Internally the address pointer is incremented
after receiving each group of sixteen clocks; however,
once the address counter reaches xxxx x111 it will roll
over to xxxx x000 with the next clock. After the last bit
is clocked in no internal write operation will occur until
CS is brought low.
Continuous Read
This begins just like a standard read with the host
issuing a read instruction and clocking out the data
byte [word]. If the host then keeps CS high and
continues generating clocks on SK, the S93662/663
will output data from the next higher address location.
The S93662/663 will continue incrementing the ad-
dress and outputting data so long as CS stays high. If
the highest address is reached, the address counter
will roll over to address 0000. . CS going low will reset
the instruction register and any subsequent read must
be initiated in the normal manner of issuing the com-
mand and address.
2012 2.0 4/18/00
4