MC73110 Datasheet, PDF (22/40 Pages) List of Unclassifed Manufacturers – Advanced 3-Phase Motor Control IC

3
Using Pro-Motion
3.1 Communication
When Pro-Motion is started it will attempt to connect to the DK Board via the the serial port using the default
serial port settings. If it cannot communicate to the DK Board (or File/New is selected) the Interface selection
dialog is displayed. Make sure the interface setting is set to COM port and the selected port is the one the DK
Board is attached to.
If the serial interface (COM port) is selected in the Interface selection dialog, the serial communication configura-
tion screen is displayed.
Make sure the serial cable is connected from the host computer’s COM port to the DK Board. Set the serial
interface parameters according to the default settings of 57600, None, 2, Point to point, 0. Click OK to attempt a
connection and proceed to the Axis Setup Wizard. If no connection is made the Interface selection dialog will be
displayed again allowing you to modify the interface parameters or run in demo mode.
22
MC73110 Developer’s Kit Manual