SA9904B Datasheet, PDF (2/12 Pages) List of Unclassifed Manufacturers – Three Phase Power / Energy IC with SPI Interface

SA9904B
sames
ELECTRICAL CHARACTERISTICS
(VDD = 2.5V, VSS = -2.5V, over the temperature range -10°C to +70°C^#, unless otherwise specified.)
Parameter
Symbol
Min
Typ
Max
Unit
Operating temp. Range
TO
Supply Voltage: Positive
VDD
Supply Voltage: Negative
VSS
Supply Current: Positive
IDD
Supply Current: Negative
ISS
Current Sensor Inputs (Differential)
-25
+85
°C
2.25
2.75
V
-2.75
-2.25
V
9.5
11
mA
9.5
11
mA
Input Current Range
III
-25
+25
µA
Voltage Sensor Input (Asymmetrical)
Input Current Range
IIV
-25
+25
µA
Pins SCK
High Voltage
Low Voltage
Pins CS, DI
High Voltage
Low Voltage
Pins F50, DO
Low Voltage
High Voltage
Oscillator
Pin VREF
Ref. Current
Ref. Voltage
VIH
VDD-1
VIL
fSCK
tLO
0.6
tHI
0.6
VIH
VDD-1
VIL
V
VSS+1
V
800
kHz
µs
µs
V
VSS+1
V
VOL
VOH
VDD-1
VSS+1
V
V
Recommended crystal: TV colour burst crystal f = 3.5795 MHz
-IR
23
25
27
µA
VR
1.1
1.3
V
Condition
Peak value
Peak value
IOL = 5mA
IOH = -2mA
With R = 47kW
connected to VSS
Reference to VSS
ABSOLUTE MAXIMUM RATINGS*
Parameter
Symbol
Min
Max
Unit
Supply Voltage
VDD -VSS
3.6V
6.0
V
Current on any pin
IPIN
-150
+150
mA
Storage Temperature
TSTG
-40
+125
°C
Operating Temperature
TO
-40
+85
°C
*Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress
rating only. Functional operation of the device at these or any other condition above those indicated in the operational sections of
this specification, is not implied. Exposure to Absolute Maximum Ratings for extended periods may affect device reliability.
During manufacturing, testing and shipment we take great care to protect our products against potential
external environmental damage such as Electrostatic Discharge (ESD). Although our products have ESD
protection circuitry, permanent damage may occur on products subjected to high-energy electrostatic
discharges accumulated on the human body and test equipment and can discharge without detection.
Therefore, proper ESD precautions are recommended to avoid performance degradation or loss of
functionality during product handling.
http://www.sames.co.za
2₃/12