T-51513-D104U-FW-A-AB Datasheet, PDF (18/19 Pages) List of Unclassifed Manufacturers – LCD Module Technical Specification

h. Please do not touch metal frames with bare hands and soiled gloves. A color change of the
metal frames can happen during a long preservation of soiled LCD modules.
i. Please pay attention to handling lead wire of backlight so that it is not tugged in connecting
with inverter.
j. Please connect the metal frame of LCD module to GND in order to minimize the effect of
external noise and EMI.
k. Please connect the metal frame of LCD module to GND in order to minimize the effect of
external noise and EMI.
(2) OPERATING PRECAUTIONS
a. Please be sure to turn off the power supply before connecting and disconnecting signal
input cable.
b. Please do not change variable resistance settings in LCD module. They are adjusted to the
most suitable value. If they are changed, it might happen LCD does not satisfy the
characteristics specification.
c. LCD backlight takes longer time to become stable of radiation characteristics in low
temperature than in room temperature.
d. A condensation might happen on the surface and inside of LCD module in case of sudden
change of ambient temperature.
e. Please pay attention not to display the same pattern for very long time. Image might stick on
LCD. Even if image sticking happens, it may disappear as the operation time proceeds.
f. Please obey the same safe instructions as ones being prepared for ordinary electronic
products.
(3) PRECAUTIONS WITH ELECTROSTATICS
a. This LCD module use CMOS-IC on circuit board and TFT-LCD panel, and so it is easy to be
affected by electrostatics. Please be careful with electrostatics by the way of your body
connecting to the ground and so on.
b. Please remove protection film very slowly from the surface of LCD module to prevent from
electrostatics occurrence.
(4) STORAGE PRECAUTIONS
a. Please do not leave the LCDs in the environment of high humidity and high temperature
such as 60°C90%RH.
T-51513-D104U-FW-A-AB (AB) No. 2002-0186
OPTREX CORPORATION
Page 19/37