T-51513-D104U-FW-A-AB Datasheet, PDF (17/19 Pages) List of Unclassifed Manufacturers – LCD Module Technical Specification

11. HANDLING PRECAUTIONS FOR TFT-LCD MODULE
Please pay attention to the followings in handling TFT-LCD products;
(1) ASSEMBLY PRECAUTION
a. Please use the mounting hole on the module in installing and do not bending or wrenching
LCD in assembling. And please do not drop, bend or twist LCD module in handling.
b. Please design display housing in accordance with the following guide lines.
(a) Housing case must be designed carefully so as not to put stresses on LCD all sides and
not to wrench module. The stresses may cause non-uniformity even if there is no non-
uniformity statically.
(b) Keep sufficient clearance between LCD module back surface and housing when the
LCD module is mounted. Approximately 1.0mm of the clearance in the design is
recommended taking into account the tolerance of LCD module thickness and mounting
structure height on the housing.
(c) When some parts, such as, FPC cable and ferrite plate, are installed underneath the
LCD module, still sufficient clearance is required, such as 0.5mm. This clearance is,
especially, to be reconsidered when the additional parts are implemented for EMI
countermeasure.
(d) Design the inverter location and connector position carefully so as not to give stress to
lamp cable, or not to interface the LCD module by the lamp cable.
(e) Keep sufficient clearance between LCD module and the others parts, such as inverter
and speaker so as not to interface the LCD module. Approximately 1.0mm of the
clearance in the design is recommended.
c. Please do not push or scratch LCD panel surface with anything hard. And do not soil LCD
panel surface by touching with bare hands. (Polarizer film, surface of LCD panel is easy to
be flawed.)
d. Please do not press any parts on the rear side such as source TCP, gate TCP, control circuit
board and FPCs during handling LCD module. If pressing rear part is unavoidable, handle
the LCD module with care not to damage them.
e. Please wipe off LCD panel surface with absorbent cotton or soft cloth in case of it being
soiled.
f. Please wipe off drops of adhesives like saliva and water on LCD panel surface immediately.
They might damage to cause panel surface variation and color change.
g. Please do not take a LCD module to pieces and reconstruct it. Resolving and reconstructing
modules may cause them not to work well.
T-51513-D104U-FW-A-AB (AB) No. 2002-0186
OPTREX CORPORATION
Page 18/37