NRF2401 Datasheet, PDF (17/37 Pages) List of Unclassifed Manufacturers – Single chip 2.4 GHz Transceiver

PRODUCT SPECIFICATION
Q5) 6LQJOH &KLS  *+] 5DGLR 7UDQVFHLYHU
&RQILJXUDWLRQ :RUG RYHUYLHZ
%LW 1XPEHU
SRVLWLRQ RI ELWV
1DPH
143:120
119:112
111:104
103:64
63:24
23:18
17
24 TEST
8
DATA2_W
8
DATA1_W
40 ADDR2
40 ADDR1
6
ADDR_W
1
CRC_L
)XQFWLRQ
Reserved for testing
Length of data payload section RX channel 2
Length of data payload section RX channel 1
Up to 5 byte address for RX channel 2
Up to 5 byte address for RX channel 1
Number of address bits (both RX channels).
8 or 16 bit CRC
16
1
CRC_EN
Enable on-chip CRC generation/checking.
15
1
RX2_EN
Enable two channel receive mode
14
1
CM
Communication mode (Direct or ShockBurst™)
13
1
RFDR_SB
RF data rate (1Mbps requires 16MHz crystal)
12:10
3
XO_F
Crystal frequency
9:8
2
RF_PWR
RF output power
7:1
7
RF_CH#
Frequency channel
0
1
RXEN
RX or TX operation
Table 8 Table of configuration words.
The configuration word is shifted in MSB first on positive CLK1 edges. New
configuration is enabled on the falling edge of CS.
NOTE.
On the falling edge of CS, the nRF2401 updates the number of bits actually shifted in
during the last configuration.
Ex:
If the nRF2401 is to be configured for 2 channel RX in ShockBurst™, a total of 120
bits must be shifted in during the first configuration after VDD is applied.
Once the wanted protocol, modus and RF channel are set, only one bit (RXEN) is
shifted in to switch between RX and TX.
Nordic VLSI ASA - Vestre Rosten 81, N-7075 Tiller, Norway - Phone [phone] - Fax [phone]
Revision: 1.0
Page 17 of 37
March 2003